Site work and paving for a road / highway in Golden Valley, Minnesota. Completed plans call for site work for a road / highway; and for paving for a road / highway.

The Work will consist of sawing or routing, measuring, cleaning and sealing cracks in the existing bituminous pavement. Contractor shall provide certification that the sealant meets the requirements of MNDOT Standard Specification 3723. The crack sealant compound shall be packaged in sealed containers. Each container shall be clearly marked with the name of the manufacturer, the trade name of the sealant, the manufacturer's batch and lot number, the pouring temperature, and the safe heating temperature. A copy of the manufacturer's recommendations pertaining to the heating and application of the joint sealant material shall be submitted to the Engineer prior to commencement of work. These recommendations shall be adhered to and followed by Contractor. The temperature of the sealer in the field application equipment shall never exceed the safe heating temperature recommended by the manufacturer. Any given quantity of material shall not be heated at the pouring temperature for more than six (6) hours and shall never be reheated. Sealing shall not proceed if the temperature of the material has not reached or has fallen below the manufacturer's recommended minimum application temperature. Contractor certifies that an examination has been made of the scope and location of work and proposes to furnish all necessary machinery, equipment, tools, labor and other means for the Work and to furnish all materials specified in the manner and at the time prescribe; and understands that the quantities of work shown herein are approximate only and are subject to increase or decrease; and further understands all quantities of work, whether increased or decreased, are to be performed at the following unit prices. Any questions related to the proposal, please contact Marshall Beugen at 763-593-8085 or mbeugen@goldenvalleymn.gov. The Contractor shall proceed diligently and shall complete the Work to the satisfaction and approval of the City's engineer between May 1st and July 14, 2024 (the "Contract Time"). Contractor shall to notify the City in writing of any cause of delay of the Work within 24 hours after such cause of delay arises. If Contractor fails to complete the Work by the Contract Time, the City may immediately, or at any time thereafter, proceed to complete the Work at the Contractor's expense. If Contractor gives written notice of a delay over which Contractor has no control, the City may, at its discretion, extend the Contract Time. *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document.