Demolition, site work, renovation and addition to a fire / police facility in El Paso, Texas. Completed plans call for the renovation of a fire / police facility; for the demolition of a fire / police facility; for site work for a fire / police facility; and for the addition of a fire / police facility.

The Project consists of the alteration of an existing fire station, of about 7,065 square feet, with an addition of new facilities. It includes but not limited to cutting and patching for new interior finishes, new HVAC, new plumbing, new electrical, walls, new ceilings, new windows, and doors (including new frames), new structural, new exterior wall and roofing The City reserves the right, at its sole discretion, to adjust this Schedule of Events as it deems necessary. If necessary, the City will communicate adjustments to any event in the Schedule of Events in the form of an amendment. Question Deadline 05/22/2024 at 5:00 PM MT SCOPE OF WORK A. The Work included under this Contract consists of the furnishing and installation of all equipment and material necessary and required to form the complete and functioning systems in all of its various phases, all as shown on the accompanying Drawings and/or described in these Specifications. The contractor shall review all pertinent drawings, including those of other contracts prior to commencement of Work. B. This Division requires the furnishing and installing of all items Specified herein, indicated on the Drawings or reasonably inferred as necessary for safe and proper operation; including every article, device or accessory (whether or not specifically called for by item) reasonably necessary to facilitate each system's functioning as indicated by the design and the equipment specified. Elements of the work include, but are not limited to, materials, labor, supervision, transportation, storage, equipment, utilities, all required permits, licenses and inspections. All work performed under this Section shall be in accordance with the Project Manual, Drawings and Specifications and is subject to the terms and conditions of the Contract. C. The approximate locations of Electrical items are indicated on the Drawings. These Drawings are not intended to give complete and accurate details in regard to location of outlets, apparatus, etc. Exact locations are to be determined by actual measurements at the building, and will in all cases be subject to the Review of the Owner or Engineer, who reserves the right to make any reasonable changes in the locations indicated without additional cost to the Owner. D. Items specifically mentioned in the Specifications but not shown on the Drawings and/or items shown on Drawings but not specifically mentioned in the Specifications shall be installed by the Contractor under the appropriate section of work as if they were both specified and shown. E. All discrepancies within the Contract Documents discrepancies between the Contract Documents and actual job-site conditions shall be reported to the Owner or Engineer so that they will be resolved prior to the bidding, where this cannot be done at least 7 working days prior to bid; the greater or more costly of the discrepancy shall be bid. All labor and materials required to perform the work described shall be included as part of this Contract. F. It is the intention of this Section of the Specifications to outline minimum requirements to furnish the Owner with a turn-key and fully operating system in cooperation with other trades. G. It is the intent of the above Scope to give the Contractor a general outline of the extent of the Work involved; however, it is not intended to include each and every item required for the Work. Anything omitted from the Scope but shown on the Drawings, or specified later, or necessary for a complete and functioning electrical system shall be considered a part of the overall Scope. H. The Contractor shall rough-in fixtures and equipment furnished by others from rough-in and placement drawings furnished by others. The Contractor shall make final connection to fixtures and equipment furnished by others. I. Contractor shall participate in the commissioning process; including but not limited to meeting attendance, completion of checklists and participation in functional testing.