Renovation of a residential development in Milwaukee, Wisconsin. Completed plans call for the renovation of a residential development.

Financing for work under this contract is provided through the City of Milwaukee, Neighborhood Improvement Development Corporation (NIDC) who, through its loan agreement with the Owner, reserves certain rights and privileges as Lender, which include but are not limited to: development of the scope of work, assistance with the bid process, preparation of the Contract, approval of change orders and payments, and other aspects associated with contract execution and implementation. The Owner reserves the right to reject any and all bids and to waive informalities 1) Concrete- Demo and remove 2 concrete pads at beginning of driveway/city street. Prepare surface, form and pour new pads. 2) Front and Side Door Access Ramps- Demo and remove ramps at both doors. Rebuild new ramps and guardrails at both doors to ADA and Code compliance. 3) Grading- Remove and dispose of decorative blocks and bricks from exterior of home. Regrade using topsoil fill around rear foundation and between new side door access ramp and the foundation. Grading depth to be a minimum of 6" and sloping away from the home. 4) Window Caulking- Remove old caulking on the exterior of the living room picture windows and replace with exterior rated caulking. 5) Fence Gate- Repair rear yard fence gate to operable condition. 6) Downspout- Install new aluminum, k-style downspout at South-East corner of home. Extend downspout away from the foundation of the home at a minimum of 4' and avoiding discharge across sidewalks/driveway/ramps. Provide splashblock at point of discharge. 7) Electrical- Install 1 GFCI at laundry tub for washer and 1 GFCI to the left of the kitchen sink. Switchplates to the left of the kitchen sink are to be enclosed properly to ensure no water penetration. New exhaust fan to be installed above the kitchen stove and vented to the exterior of the home using the previous pathway of the broken vent fan. Patch, prime and paint to color match any ceiling drywall that is affected/disturbed during installation of new exhaust fan. New exhaust fan to be switch operated and installed by licensed electrician to meet code compliance. Exterior louver for exhaust fan to be pest proof. 8) HVAC- Dryer venting to be repaired and re-installed to code compliance.