This is a service / maintenance or supply contract in Baton Rouge, Louisiana. Contact the soliciting agency for additional information.

This specification sets forth the requirements for NEMA Standards Publication TS 2-2021 compliant ground mount and pole mount TS 2 Traffic Signal Cabinet assemblies. Cabinets shall include all equipment, features and functions specified herein and must be compatible with both Type 1 and Type 2 NEMA TS 2 Cubic/TrafficWare Series 900 ATC, Model No. 980-B240 controller units. Controller shall not be provided with the assemblies. GROUND MOUNT TS 2 CABINET: Product ID 51050 Ground mount assemblies shall include: ? One (1) TS 2 Power Supply ? One (1) Solid State, Type III, Two-Circuit Flasher ? Eight (8) Flash Transfer Relays ? Sixteen (16) Load Switches ? Four (4) 12-Position Field Terminal Strips ? Two (2) 4-Channel Loop Detector Cards ? One (1) 16-Channel, TS 2 Detector Card Rack ? One (1) 16-Channel Solid State Malfunction Management Unit 2 (MMU2) ? Four (4) Bus Interface Units (BIUs) ? One (1) Global Positioning Device (GPS) and Cable Assembly ? Additional Equipment and Hardware as Specified Herein The ground mount cabinet shall measure 44” to 46” W x 67” to 77” H x 24” to 26” D and have a fully open bottom. The bottom of the cabinet shall have enough surface clearance around the bottom edge to fit four (4) 5/8” concrete anchor bolts, centered at least 1-1/2” from the edge, in each corner. POLE MOUNT TS 2 CABINET: Product ID 51060 Pole mount cabinet assemblies shall include: ? One (1) TS 2 Power Supply ? One (1) Solid State, Type III, Two-Circuit Flasher ? Six (6) Flash Transfer Relays ? Twelve (12) Load Switches ? Three (3) 12-Position Field Terminal Strips ? One (1) 4-Channel Loop Detector Card ? One (1) 16-Channel, TS 2 Detector Card Rack ? One (1) 16-Channel Solid State Malfunction Management Unit 2 (MMU2) ? Three (3) Bus Interface Units (BIUs) ? One (1) Global Positioning Device (GPS) and Cable Assembly ? Additional Equipment and Hardware as Specified Herein The pole mount cabinet shall measure 30” to 36” W x 52” to 62” H x 15” x 17” D. The bottom of the cabinet shall have two (2) holes, one (1) 3-1/2” to 3-5/8” and one (1) 1-1/4” to 1-3/8”. Each hole shall be provided with a National Pipe Thread (NPT) Myers hub. See Figure 1. Pole mount cabinets shall be provided with two (2) C-shape cabinet mounting brackets and a permanently installed reinforcement plate. The mounting brackets shall be pre-attached with bolts to the back of the pole mounted cabinet reinforcement plate. Brackets must have slots for ¾” banding material and reinforcement plate must be designed to support the weight of the cabinet and the equipment intended to be contained within.