Site work for a power facility in Winfield, Kansas. Completed plans call for site work for a power facility.

following classification(s) of work: 1. Demolition 2. Mechanical 3. Electrical 4. Plumbing All contractors bidding as the prime bidder on this project must be pre-qualified with Office of Facilities and Property Management to bid this project. For instructions on pre-qualification go. Value: $100,000 to $250,000 *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. Questions concerning the Instructions to Bidders, Form of Contract, Insurances and Bonds shall be addressed to the Office of Procurement and Contracts, Department of Administration, Suite 451S, 900 S.W. Jackson Street, Topeka, Kansas 66612, telephone (785) 296-0002. Each bid submitted in connection with this Project shall be accompanied by a certified check, cashiers check or bid bond in the amount of five percent (5%) of the base bid, payable without condition to the State of Kansas A Certificate of Deposit, in an amount of 100% of the Contract amount, may be substituted for a Performance and Public Works Bond. Clarifications and interpretations of the Construction Contract Documents will be made only by Addenda issued to all known persons having same. The Project Architect/Engineer, state agency personnel or Procurement and Contracts will not be resp If there is a disclaimer of any responsibility by the Project Architect/Engineer for construction documents other than those specifically authenticated by their seal, it in no way waives their contractual obligation to coordinate all the construction documents on the project. Questions concerning the Construction Contract Documents (Drawings and Specifications) shall be addressed to the Design Team at: DAVID GRIFFITH, ENGINEER ORAZEM & SCALORA ENGINEERING 2312 ANDERSON AVENUE MANHATTAN, KANSAS 66502 PHONE: 785-537-2553 E-MAIL ADDRESS: daveg@osepa.com All questions and requests to approve equivalent products must be submitted to the engineer no later than April 5th, 2024. All responses and approvals will be released via addendum and posted through the plan distribution website.