Site work and paving for a road / highway in Troy, Montana. Completed plans call for site work for a road / highway; and for paving for a road / highway.

SPECIFICATIONS FOR WORK: Contractor will provide all labor, equipment, materials, incidentals, and traffic control necessary to produce, haul, place, tack and compact approximately 5,950 tons of 1/2 " Commercial Plant Mix Grade S 64-28 asphalt mix material. The overlay shall be paved .15 feet thick and approximately 28-52 feet wide. Contractor shall provide all labor, equipment, materials, incidentals, and traffic control necessary to produce, haul, place, roll and broom approximately 34,115 square yards of laid-in-place chip seal. The chip seal will be approximately 1.4 miles long and 28-52 feet wide. Contractor shall provide CHFRS-2P asphalt emulsion and Type 1 chips. Traffic control with pilot cars must be maintained until dusk or fading light each workday as determined by the Project Manager. The emulsion application rate for chip seals is estimated at 0.45 gallons per square yard. The cover material application rate is estimated at 25 pounds per square yard. Actual application rates will be based on the chip design and the actual field adjustments. If the cover material application rate of 25 pounds per square yard is not sufficient to provide a quality job, the Project Managers will jointly determine what the new application rate should be. Contractor must furnish a water truck for dust control and wetting of chips. Arrangements must be made by the Contractor for acquiring water for wetting and sweeping. It will be the responsibility of the Contractor to determine the centerline and place reflective tabs prior to the chip seal. The Contractor will provide all labor, equipment, and materials to provide temporary, interim, and final striping. Contractor shall be responsible for all private property damage claims resulting from performance of the tasks described above. DESIGNATED CONTRACT DATE: WORK CANNOT BEGIN UNTIL AFTER: JULY 1, 2024 WORK IS REQUIRED TO BE COMPLETED ON OR BEFORE: JUNE 30, 2025 Question Submission Close Date 5/20/2024 2:00 PM MDT