Renovation of a municipal facility in Corinth, Mississippi. Completed plans call for the renovation of a municipal facility.

For the purpose of replacing the roof for the Corinth office at 2701 County Rd. 402. Questions and Requests for Clarification to AW Deadline: July 23, 2024 All questions and requests for clarifications must be directed by email to: Eric Davis Telephone: 601-853-5245 E-mail: EDavis@mdrs.ms.gov Contractor shall provide services, and otherwise do all things necessary for or incidental to the performance of work, as set forth below. All material, labor, and equipment is required for the following scope of work. Any manufacturer that is mentioned in the specification shall be considered generic and like kind material and systems from manufacturers shall be acceptable: Shingle roof 1. Remove the shingles and felt to the roof. 2. Inspect the roof deck for any weak decking. 3. Provide a per piece price for replacement of each sheet of 4x8 decking. 4. Provide and install synthetic underlayment over all roof decking. 5. Provide and install ice and water shield the entire length of all valleys. 6. Provide and install all new flashing to match existing in profile and design, color to match. 7. Provide and install new lifetime warranty architectural shingles. Flat roof 1. Prepare existing roof for reroofing by cutting existing roof into 10x10 grids. 2. Mechanically fasten one (1) layer of 1" polyisocyanurate roof insulation over the existing roof. 3. Install a 60 mil mechanically attached white TPO roof system with required flashings. 4. Extend TPO membrane up and over parapet walls and terminate with new parapet cap. 5. Flash parapet walls where warehouse meets office as required per manufacturer's recommendations. 6. Install new 24 gauge white or dark bronze prefinished parapet cap and perimeter flashing. 7. Install retrofit drains in the five (5) existing drain locations. 8. Furnish manufacturer's fifteen (15) year standard watertight warranty. 9. Furnish contractor's two (2) year warranty. 10. If necessary, Contractor to disconnect and remove/raise HVAC, electrical lines, gas lines, satellites, etc. as required before reroofing and reconnect after new roof is in place. Production Building Roof 1. Install a Rhino bond TPO roofing system over existing metal roof. 2. Install wood blocking as required to secure the roof per manufacturers requirements. 3. Cover existing skylights with metal panels before a new TPO roof is installed. 4. Install EPS flue filler between the panel highs. 5. Install 1.5" Poly-Iso Insulation over the entire roof area. 6. Install a white, 60 mil Rhino Bond TPO roof system. 7. Seal around roof penetrations. 8. Install standard colored, 24-gauge, shop ben metal flashing as required for the new roof system. 9. Install new standard color, 24-guage, shop bent gutters and downspouts. 10. Provide a two-year workmanship warranty. 11. Provide a 20-year Manufacturer warranty on the TPO roofing system.