BLOCK PAGE!!!

Subscribe For Access

Privately Funded

Bidding Soon

Documents Available

Publicly Funded

Addenda Available

Post-Bid

Saving Project...

Eat some turkey, then gobble up construction leads.

Our commercial construction data is best paired with a recliner and some football.

This is a service / maintenance or supply contract in Scott Air Force Base, Illinois. Contact the soliciting agency for additional information.

THE FOLLOWING EQUIPMENT WILL BE COVERED FOR MAINTENANCE BY THE CONTRACTOR: 4- Mod Con boilers for H.P loop 2-Cooling tower pumps 1-BAC cooling tower 2-Condenser pumps 4-Chilled water pumps 4-Domestic hot water heaters 1-Multi stack chiller 1-Trane rooftop 1-Innovent Air handler (see attachment 1) THE FOLLOWING SERVICES WILL BE PERFORMED BY THE CONTRACTOR FOR LISTED EQUIPMENT: 1. Contractor will service packaged rooftop units quarterly to include: a. Check the refrigerant charge b. Lubricate motors and bearing as recommended by the manufacturer c. Check belts for excessive wear and fatigue, adjust tension, replace quarterly, customer supplied d. Visually inspect electrical components e. Check major electrical connections, tighten as required f. Record volt/amps of major electrical components g. Check crankcase heater 2. Contractor will service heating boilers to include: a. Inspect and clean the waterside quarterly b. Inspect economizers, deaerators, and condensate receivers quarterly c. Check the refractory quarterly d. Burner inspection e. Inspect controls for proper operation f. Check the fluid levels on hydraulic valves and repair any signs of leakage g. Check filters and clean or replace them quarterly h. Check boiler feedwater and recirculation pumps i. Empty and wash out condensate receivers and make an internal inspection j. Check electrical connections on starters and relays for tightness k. Inspect and clean the fireside quarterly l. Recommended PM kits will be invoiced separately if needed 3. Contractor will service chillers to include: a. Clean condenser tube bundles annually b. Check coupling bolts c. Tighten main starter and control panel connections d. Check all safeties e. Check operating controls f. Check refrigerant and leak check machine g. Log all operating conditions after unit stabilizes h. Calibrate stater sensor annually i. Contractor is to be certified on Dan Foss compressors 4. Contractor will service cooling towers to include: a. Lubricate fan and motor bearings as per Manufacturer's recommendation b. Change V-belts customer supplied c. Check motor pulley, motor mounts, and bearings; adjust as required d. Inspect electrical connections, contactors, relays and operating/safety controls e. Check motor operating conditions f. Clean electronic eye system for proper operation g. Clean basin (bottom of cooling tower) and sump tank annually h. Contractor must be familiar with Metasys system 5. Contractor will service pump skids to include: a. Lubricate pump bearings quarterly b. Lubricate motor bearings quarterly c. Check motor mounts and vibration pads d. Visually check pump alignment and coupling condition e. Check motor operating conditions f. Inspect electrical connections and contactors g. Inspect mechanical seals h. Check suction and discharge pressure i. Check packing or mechanical seal for leaks 6. Contractor will service the gas-fired water heater for domestic heating to include: a. Flush and clean two (2) times per year water only flush b. Lubricate the fan motor as recommended c. Check and test the pilot, ignition and safety controls 7. Contractor will service air handling units to include: a. Lubricate motors and bearing as recommended by the manufacturer b. Visually inspect electrical components c. Check major electrical connections, tighten as required d. Record volt/amps of major electrical components e. Replace air filters two (4) times per year supplied by customer f. Inspect heat wheel and v-belt to include proper maintenance and cleaning 8. Additional Work In Scope: a. Scheduled Repairs - Deficiencies discovered during inspections, and not covered by the annual maintenance fee will be corrected on a time and material basis. All cost associated with any deficiencies will be discussed with the customer and contractor is required to obtain prior approval before any work is performed. i. Lodging Manager ii. Assistant Lodging Manager iii. Operations Manager iv. Maintenance Supervisor v. Maintenance Worker vi. Contracting Officer 9. Service Intervals and Payment Schedules: a. Contractor will perform four (4) inspections annually; one (1) inspection each quarter. A written report will be submitted to customer following each inspection. The report will detail the work performed during the inspection and identify areas of concern, together with recommendations for repairs. b. Annual maintenance fee will be invoiced in four (4) installments at time of inspection.

Post-Bid

Military

Public - Federal

Service, Maintenance and Supply

We’ve obtained documents for this project and are currently processing them.

Subscribe For Documents

3 Record(s)

Subscribe for All Details

Trades Specified

Division 00 - Lorem Ipsum

Division 00 - Lorem Ipsum

Lorem, Ipsum, Dolor, Sit amet

Find More Local Projects

Within 75 Miles of This Project
85
Active Projects
55
Bidding Soon
804
All Active Projects
321
Updated Recently

You’ve Reached the Free View Limit

Want to see more project and bidder data in your market? Check out our product options and see what works best for you and your business.

Come back in [[refresh_days]] to get [[project_count]] more free projects.

July 25, 2024

August 26, 2024

img_map_placeholder

South Dr, Scott Air Force Base, IL

Related To This Project


The data you need to build the relationships you want. Try it free.

Access Now

Get the right
data with Project Intelligence

Share with your network.

Project Shared

with

example@example.com

Upgrade now for industry‑leading commercial construction data.

You've reached the free-view limit.

Thousands of projects are added every week - don't miss out. Explore the best product options for your business and subscribe today.

Get Access Now

Choose what you would like to do.

Seen enough? Want to see more? Subscribe on your own or talk to one of our sales reps.

Fuel growth with access to the bidding project info your business needs.

Full details, including key contact information, important dates, plans and specifications, on over 500,000 Projects including 5000 updated daily available to subscribers.