Renovation of an educational facility in Manorville, New York. Completed plans call for the renovation of a educational facility.

**As of September 09, 2024, the award amount is $1,413,455.76. Each proposal submitted must be accompanied by a certified check or bid bond, made payable to the EASTPORT-SOUTH MANOR CENTRAL SCHOOL DISTRICT, in an amount equal to ten percent (10%) of the total amount of the bid, as a commitment by the bidder that, if its bid is accepted, it will enter into a contract to perform the work and will execute such further security as may be required for the faithful performance of the contract. CERTIFICATION OF BONDING COMPANY IS REQUIRED FOR THIS BID, SEE INSTRUCTIONS FOR BIDDERS. The Board reserves the right to reject any or all bids, waive any informality and to accept such bid which, in the opinion of the Board, is in the best interests of the School District. The Contractor shall, if required by ordinances, laws, codes, rules and/or regulations of the governing agencies having jurisdiction over this project, retain a licensed professional engineer to supervise the construction of this project including, but not limited to, foundations, structural work, soils, welding, reinforced masonry and the like. Phase 2 Building Upgrades at Dayton Avenue Elementary School - M-2 Plans and Specifications may be obtained from Revplans, 28 Church Street, Unit 7, Warwick, New York 10990, upon deposit of One Hundred Dollars ($100.00) for each combined set of documents, Checks or money orders shall be made payable to Eastport-South Manor Central School District, checks should be sent directly to REVplans. Bidders deposit will be refunded if the set is returned to REV in good condition within thirty (30) days following the award of the contract or the rejection of the bids covered by such plans and specifications. SCOPE OF WORK A. Broad Scope: Asbestos containing materials (ACM) have been identified at the project site. Samples of various suspect materials have been collected and analyzed; additional samples may be required as existing materials are removed or revealed during the course of work. The scope of work and procedures outlined herein shall be followed by a New York State Department of Labor (NYS DOL) certified asbestos abatement contractor. B. Related Sections: 1. Section 022600 - HAZARDOUS MATERIALS ASSESSMENT. C. SCOPE OF WORK 1. Removal of the following items described in the asbestos survey as positive for asbestos, in accordance with NYSDOL Industrial Code Rule (ICR) 56: a. Refer to contract drawings and environmental reports for asbestos containing materials which require abatement. 2. 3. 4. 5. Asbestos Containing materials must be removed only by a New York State Department of Labor (NYS DOL) licensed asbestos abatement contractor (herein referred to as the Contractor). The Contractor shall be aware of all conditions of the Project and is responsible for field verifying quantities and locations of all ACM to be removed from the building prior to submission of any bid. Failure to do so shall not relieve the Contractor of its obligation to furnish all labor and materials necessary to perform the Work. The quantities presented in this Specification are approximate and should not be used solely as the basis for any bid. In the event that suspect materials not included in this Specification are encountered while the work is in progress, such material shall be tested for asbestos content or assumed positive for asbestos content, and removed in accordance with the procedures herein. Any discovery of new ACM shall not delay the progress of the Work. Payment for any additional work shall be considered on a case-by-case basis by the Engineer and Owner. All Work shall be performed in strict accordance with the Contract Documents and all applicable codes, rules, and regulations. Where conflicts occur between the Contract Documents and applicable codes, rules, and regulations, the more stringent shall apply. The Contractors industrial hygiene practices during asbestos abatement will be monitored by the Owners representative. The Contractor shall be responsible for monitoring his own construction safety work practices for compliance with the OSHA regulations.