Demolition, site work, renovation and addition to a mixed-use development in Burleson, Texas. Completed plans call for the renovation of a fire / police facility; and for the addition of a municipal facility.

The City of Burleson is requesting Competitive Sealed Proposals (RFCSP) with the intent of awarding a contract for a General Contractor to complete a renovation and addition of the City of Burleson Fire Station #1 located at 828 SW Alsbury Boulevard, Burleson, Texas, 76028. Questions Due Date: Oct 4th 2024, 5:00 PM CDT SCOPE OF WORK A. The controls contractor shall furnish and install a complete building automation system including all necessary hardware and all operating and applications software necessary to perform the control sequences of operation as called for in this specification. Network level components of the system - workstations, servers, etc. shall communicate using the BACnet protocol, as defined by ASHRAE Standard 135-2004, or EIA standard 709.1. No gateways shall be used for communication to controllers furnished under this section. At a minimum, provide controls for the following: 1. Direct Expansion Rooftop Units 2. Exhaust air fans 3. Terminal Units. 4. Monitoring points for packaged equipment such as emergency generators, walk-in coolers, and water detection etc. 5. Power wiring to DDC devices, smoke control dampers, and BAS panels except as otherwise specified. B. Except as otherwise noted, the control system shall consist of all necessary Ethernet Network Controllers, Standalone Digital Control Units, Room Controllers, workstations, software, sensors, transducers, relays, valves, dampers, damper operators, control panels, and other accessory equipment, along with a complete system of electrical interlocking wiring to fill the intent of the specification and provide for a complete and operable system. Except as otherwise specified, provide operators for equipment such as dampers if the equipment manufacturer does not provide these. Coordinate requirements with the various Contractors. C. The BAS contractor shall review and study all HVAC drawings and the entire specification to familiarize themselves with the equipment and system operation and to verify the quantities and types of dampers, operators, alarms, etc. to be provided.