Renovation of a multi-residential development in New York, New York. Completed plans call for the renovation of a multi-residential development.

Location: 25-10 84th Street Jackson Heights NY 11372 Supply & Install New 12"x 12" Ceramic Tile Flooring Inside Entire Basement of Home Replace existing flooring per scope of work Any questions or requests for clarification regarding the information provided may be directed to Brooklyn.CMM.Bids@opwdd.ny.gov CR Number: 2112109 Service-Disabled Veteran-Owned Set Aside: No Minority Owned Sub-Contracting Goal: 30% Women Owned Sub-Contracting Goal: 7% Service-Disabled Veteran-Owned Business Contracting Goal: 6% Q/A:- Any vendor questions not asked during the site visit must be submitted in writing to: Brooklvn.CMM.Bids@opwdd.ny.gov (within two business days of the site visit: August 1, 2024). Both questions and answers (if any) will be provided to all who attend the site visit via email by: August 6, 2024. 12"x 12" Ceramic Floor Tile Installation. The Vendor to supply and install all Materials and Labor to complete the work in a professional manner according to scope of work and architectural drawings if supplied. Work is to be completed within 14 days of award, unless modified below. This is a NYS Public Works project and prevailing wages are to be paid. Refer to attached specification for the following scope of work. Site must be cleaned, and all materials secured at the end of each workday. Absolutely no scraps, especially fasteners, are to be left unsecured. Upon completion of Flooring installation, contractor is to schedule a quality control and quality assurance inspection with Plant Superintendent. SCOPE OF WORK: Includes, but is not necessarily limited to the following: 1 Provide proper dust protection at all areas where work is to be performed. The protective barrier shall be a minimum 3 mil vapor barrier taped and properly supported to prevent dust from entering non-work areas ofthe home. All smoke detectors shall be properly covered and protected from dust at the start of work and removed at the end of each work day. 2 Remove and discard existing flooring down to the concrete. Prepare concrete to receive new flooring. Patch all areas as required to be properly leveled. 3 Remove baseboard, trim, doors, etc. as required to install new flooring and complete work. Repair wood trim as required for proper and complete job. Finish and paint all wood affected or disturbed by work to match with two coats ofBenjamin Moore or equal. 4 All closets are to be included to receive ceramic tiles. 5 Supply and install 12" x 12" ceramic Tile inside the entire basement ofthe home except the boiler room. 6 Supply and install 4" cove base ceramic Tiles with bullnose top and cove bottom. 7 Supply thin set adhesive for the installation of all new ceramic floor tiles 8 Supply and install epoxy grout for all ceramic tiles installed to be sealed in a neat through fashion. 9 Color ofthe ceramic Tile shall be a sand-based color. 10 Supply and install new quarter round wood molding in affected areas where there is no cove base. 11 Cut doors as required to install new flooring. All affected doors shall operate and close properly upon completion ofwork. 12 Move and relocate furniture back to original location as required for new floor installation. 13 Supply and install everlast or equal felt padding on all furniture in both rooms where new flooring will be installed. 14 All new Ceramic Tile Flooring installed; Contractor must adhere to manufactures installation specs foiinstallation to keep Manufactures 1 yr. Warranty valid. 15 New ceramic Tile Flooring must come with a one-year Guarantee from Vendor. 16 No asbestos or lead abatement ofmaterials is required for this project. Apprent low bidder Leyman construction LLC - New York, NY