Site work and paving for a mixed-use development in Bonita Springs, Florida. Completed plans call for site work for a road / highway; for paving for a road / highway; sidewalk / parking lot; and sidewalk / parking lot.

As of October 18,2024, project was awarded to Ajax Paving Industries of Florida LLC, but awarded amount is not available. Lee County Board of County Commissioners seeks to contract with a qualified Contractor to provide milling and resurfacing improvements to various roads within Lee County, Florida. Work shall include, but not be limited to; milling, resurfacing, restriping, ADA upgrades, and minor signal work to accommodate ADA upgrades. It has been determined that the specifications and scope of work within this solicitation are adequate to describe the product or services being requested. A pre-bid conference and site visit has not been scheduled for this solicitation. Questions regarding this solicitation are to be directed, in writing, to the individual listed below using the email address listed below or faxed to (239) 485 8383 during normal working hours. Kevin Walker, KWalker2@leegov.com Contractor shall be responsible for but not limited to the following: 2.1.1. All loops shall be installed under the asphalt and not cut in. 2.1.2. Bridges/Culverts shall be milled without damage to the existing deck. 2.1.3. All roads shall be milled 1.5" and tacked and receive a 1.5" (165lbs) avg overlay of Superpave 12.5 traffic lvl C, PG76-22 2.1.4. Any potholes or depressions shall be filled and compacted prior to paving the roadway mainline. 2.1.5. Milled surfaces may be left for up to 24 hours as long as: 2.1.5.1. They do not exceed 1 mile in length, 2.1.5.2. Have a smooth transition into and out of the milled area (minimum 6 ft transition), 2.1.5.3. And have appropriate markings for the traveling public. 2.1.6. Concrete work shall be completed prior to milling and resurfacing. 2.1.7. ADA upgrades shall be integrated at locations shown on the plans and meet 2010 ADA guidelines. 2.1.8. Asphalt repairs due to concrete work shall be performed with black base 12.5 and included in the MOT 102-1; no additional compensation shall be provided 2.1.9. Striping to match the Plan. If there is a conflict between plans and MUTCD and FDOT, FDOT prevails. 2.1.10. Driveways shall be cleaned of debris after completion of the paving operation. 2.1.11. No feathered joints at driveways and/or roadway tie-ins 2.1.12. Temp paint is incidental to the Thermoplastic installation. 2.1.13. Manholes and valve boxes may be adjusted with Metal rings as needed. 2.1.14. Millings from this project shall be the property of the winning bidder.