Renovation of a water / sewer project in Mobile, Alabama. Completed plans call for the renovation of a water / sewer project.

Vertical Turbine Pump Repair for CC Williams WWTP The following labor and materials will be supplied for the repair and installation of a Sulzer Vertical Turbine Pump (Serial #80281-05). Bidder should contact manufacturer for detailed information about pump dimensions and other manufacturer specifications for bidding purposes. Successful bidder shall confirm all dimensions and materials when pump is disassembled. Bidders proposing to use non-OEM parts for the repair of the vertical turbine pump must provide comprehensive documentation from the parts manufacturer that demonstrates the proposed parts meet or exceed the performance, durability, and quality standards of the OEM parts specified in the bid, as well as all applicable engineering standards. Failure to submit this proof of equivalency or superiority will result in the rejection of the bid. Deliver Material to CC Williams WWTP, 1600 Yeend St., Mobile, AL 36603 Contact Barry Smith: (251) 378-3503 or basmith@mawss.com Jed Barbour: (251) 222-2363 or jbarbour@mawss.com The following labor and materials will be supplied for the repair and installation of a Sulzer Vertical Turbine Pump (Serial #80281-05). Bidder should contact manufacturer for detailed information about pump dimensions and other manufacturer specifications for bidding purposes. Successful bidder shall confirm all dimensions and materials when pump is disassembled. Bidders proposing to use non-OEM parts for the repair of the vertical turbine pump must provide comprehensive documentation from the parts manufacturer that demonstrates the proposed parts meet or exceed the performance, durability, and quality standards of the OEM parts specified in the bid, as well as all applicable engineering standards. Failure to submit this proof of equivalency or superiority will result in the rejection of the bid. Suction Bowl and Impeller Supply and install new bowl assembly; machine and bore bowl to nominal size. Complete new bowl assembly must be furnished with bid design flow 17,500 GPM@30ft TDH using 161 brake horse power, and 705 RPM. The new bowl assembly will include the following new OEM parts: 1. Cast iron tube adapter 2. Iron bowl 3. Bronze tube adapter screw bearing 4. Bronze bowl bearing 5. Bronze impeller 6. Bronze liner 7. Cast iron suction bell 8. Bronze bell bearing 9. Stainless-steel impeller thrust ring, retainer, and stainless-steel bolts 10. Split key New OEM Shaft, Couplings, and Column Tubes 1. Replace Inner Column Tubes and Inner Column Tube Bushings / Bearings with new. 2. Replace all 416 stainless steel shafts (Motor, Head, Middle Line, Lower Line, and Bowl) with new 416 stainless steel shafts. 3. Replace all Line Shaft Couplings with new stainless-steel couplings. 4. Replace Head Nut (1) with new. 5. Replace Center Ring (1) with new. 6. Replace flush line with new stainless-steel flush pipe to suction bell bearing. The flush pipe will go through the pump base plate. The pipe will have brackets connected to the column and bowl flange for support. 7. Replace Flush Water Pressure Gauge (1) with new. Pressure gauge should be stainless steel liquid filled gauge containing expected pressure ranges as defined by the pump manufacturer. MAWSS reserves the right to reject any or all bids submitted, to waive any informality in any bid or in the bid process, or to terminate the bid process at any time, if deemed by MAWSS to be in MAWSS's best interest.