Site work and new construction of a mixed-use development in Kenansville, North Carolina. Working plans call for the construction of a 12,000-square-foot transportation facility; and for site work for a transportation facility.

The project location is at the Duplin County Airport in Kenansville, NC. (See photo below for approximate location). We have an estimated budget of $4,000,000 for this project. This consists of the cost of connecting utilities, tie to proposed apron, building construction (green square), and all design and contractor fees, resulting in a finished, fully usable facility that satisfies all project requirements and contract terms. DPL also wishes to make improvements on several existing hangars (green arrows). We anticipate project completion by Spring 2026. The anticipated facility will be approximately 12,000+/- square foot Hangar and with connected space office approximately 30' deep. Hangar should be designed with a fire wall so that an adjacent hangar can be constructed against this Hangar as an independent structure. See the below timeline. Preliminary needs include, but are not limited to, the following: Hangar building to be approximately 109' wide by 110' deep, with a maximum door clearance as possible and no taller than 28'. Office area to include a mix of private offices, cubicle areas, bathrooms with showers, conference rooms, break room with kitchen and storage areas. Statement from Bonding Company of the Design-Builder's ability to obtain a Payment and Performance bond of $4,000,000 Scope of Work for Existing Hangar Rehabilitation: Scope of work for existing hangar rehab is to achieve as much as the scope as possible that the remaining funds will allow. Existing hangars consist of a mixture of T-hangars and corporate hangars. Design-build team will work with DPL on what is most critical to the airport and fits within the budget. Items to be considered are the following: T-Hangar 1 & 2 1. Remove and replace exterior metal on walls and roof with 26-gauge PBR panels 2. Remove and replace lighting with three (3) LED UFO lights to each hangar space and two (2) LED UFO lights in each office space 3. Replace all rollers on doors Corporate Hangar 1 & 2 & 3 Corp Hangar 1 1. New screws on the roof 2. Metal wall liners and ceiling 3. Remove and discard old lighting, and add twelve (12) LED UFO lights 4. Rework electrical conduit as needed 5. Grind, polish, and seal the floor. Sealed so oil and fuel won't penetrate concrete. 6. Insulate hangar doors 7. Install 20' large fan 8. Paint exposed metal white Corp Hangar 2 1. New screws on the roof Corp Hangar 3 1. (2) 5-TON AC Units 2. 20' Large fan installed Begin Design Phase December 3, 2024 Begin Construction March 2025 Project Completion March 2026 Question Deadline 09/25/2024 Pre-submittal questions, other inquiries, and responses to this RFQ shall be directed to: Josh Raynor, Airport Director Duplin County Airport 260 Airport Road Kenansville, NC 28349 Josh.raynor@duplincountync.com. County policy requires minimum Disadvantaged Business Enterprise/Minority Businesses/Historically Underutilized Business participation of 10% of the total project cost or demonstrated good faith efforts of participation. The Design-Build Team shall utilize State of North Carolina approved MBE/WBE/DBE Contractors for all MBE/WBE subcontract work. For a directory of approved firms electronically. Duplin County reserves the right to reject any and all submissions for any reason.