Site work and renovation of a mixed-use development in Cold Lake, Alberta. Completed plans call for the renovation of a playground / park / athletic field; and playground / park / athletic field.

Supply, Delivery and installation of septic tanks and floors at Cold Lake Provincial Park. 1. Mobilization. 2. Contractor must supply, deliver and install up to ten (10) tanks and ten (10) floor sections. The floor shall be as follows: - Required floor dimensions are 5207 mm or 205 inches x 3658mm or 144 inches. - Must include 159mm or 6-inch ABS vent holes for each side. - Must include a cleanout/manway hatch with lid and sealant tape. The manway lid must have the ability to be secured. - The contractor will also ensure there is a knockout form that will accommodate a plastic toilet throne on each side for each stall to match the supplied building drawings (Attachment 2). - The floor section must allow for 985.0 mm or 3 feet of overhang at each doorway (Attachment 2). - The floor section shall be 152mm-203mm or 6-8 inches thick and have lifting hooks/eyes for installation. - The floor must be finished smooth for easy cleaning and must be sealed with a concrete sealer that is NOT water based. 3. The tank requirements are as follows: - Tank capacity must be 7570 Liters or 2000 gallons or greater, and no deeper than 6’2” or 1899mm to the top of the floor. - The tanks must be rated for septic use and comply with B66 guidelines. Proof of compliance is required. - The tank must follow the footprint of the supplied building drawings (Attachment 3). 4. Tanks must be ready to deliver to Cold Lake Provincial Park by December 31, 2024. All of the old buildings and tanks will be removed by this date. 5. When arriving on site for the first day the contractor must deliver at least five complete assemblies and deliver the next five by end of day on day two. A laydown area will be provided. 6. The contractor must come equipped with a picker/crane rated for the weight of the tank and floor sections for installation with a qualified operator. The contractor will be responsible for ensuring the tanks are level and ready for building installation. Alberta Parks will have an excavator on site for any digging or backfill. 7. Contractor will be required to load and set Alberta Parks provided buildings onto the installed floor sections. There will be ten buildings and it takes approximately one hour per building to set. Buildings come with load rated lifting hook and sling. 8. Contractor must be a certified septic installer, proof of certification must be provided with bid. 9. Closeout Documentation.