Renovation of a municipal facility in El Centro, California. Working plans call for the renovation of a municipal facility.

** As of October 30,2024, no bid received for this project. No definite date for the rebid.** Each bid shall be accompanied by the bid security referred to in the contract documents and the list of proposed subcontractors in the form of a certified or cashier check or a bid bond for ten percent (10%) of the maximum bid amount being proposed. A performance and payment bond must be filed for contracts involving expenditure in excess of twenty-five thousand dollars ($25,000), and may be required for contracts involving smaller expenditures at the option of COUNTY. In accordance with Paragraph 10 of the Information for Bidders, any questions to be presented at the Pre-Bid Conference must be in writing and received by COUNTY from General Contractor or subcontractor submitting a Bid on or before October 4, 2024, at 4:00 PM in the Public Works office located at 155 South Eleventh Street, El Centro, California, 92243. SCOPE OF WORK Contractor shall comply with all applicable and current local, state, and federal laws, guidelines, standards, and California building codes. Probation Department, DRC, and Juvenile Hall roof areas are in need of improvement as it has exceeded its lifespan. These improvements will require preparation, foam application and coating as described within the scope of work The Imperial County Probation Department, Day Reporting Center (DRC) and Juvenile Hall are located at 324 Applestill Road in the city limits of El Centro in Imperial County. These buildings dated from the late 1970s, are design to house over 2,000 adults and juvenile offenders and function on a 24/7 basis providing different services and supervision to these residents. IMPERIAL COUNTY JUVENILE HALL WALK-IN COOLER PROJECT 324 APPLESTILL ROAD, EL CENTRO, CA 92243 Removal and disposal of existing walk-in cooler, refrigeration line set, & refrigeration equipment. Provide a temporary cooler during the demo and installation of the new walk-in indoor cooler. Size to be determined. Provide and install a new 1T-0 wide x 15-0 deep x 8-0 high walk-in indoor cooler (refrigerator). Unit walls shall be 4 thick insulated wall panels. New exterior, interior and ceiling finishes shall be 26-gauge stucco embossed galvanized steel