Renovation of an educational facility in Dayton, Ohio. Conceptual plans call for the renovation of a educational facility.

NEC Chilled Beam Corrective Work Project Location Wright State University Dayton Campus Project Description The NEC is a laboratory facility which is heated and cooled primarily by means of an active chilled beam system. This system has experienced a large number of failures, leading to the inability to control temperature in many spaces. The corrective work is anticipated to include the design, construction and commissioning of the replacement of existing threeway valves with six-way valves, replacing two-way control valves with pressure independent control valves, modifications to the existing piping to support the valve changes, adding a reheat coil to the two DOAS air handling units, and replacing the existing out of service heat recovery chiller with a new chiller. Scope of Services The selected Commissioning Agent ("CxA"), as a portion of its required Scope of Services and prior to submitting its proposals, will discuss and clarify with the Owner and/or the Contracting Authority, the cost breakdown of the Consultant Agreement detailed cost components to address the Owner's project requirements. Participate in the Encouraging Growth, Diversity & Equity ("EDGE") Program as required by statute and the Agreement. As required by the Agreement, and as properly authorized, provide the following categories of services: Program Verification, Schematic Design, Design Development, Construction Document Preparation, Construction Administration, Post-Construction, and Additional Services of all types. C. Funding / Estimated Budget Total Project Cost $1,900,000 State Funding $0 Construction Cost $1,600,000 Other Funding $1,900,000 Estimated CxA Fee 3.0% to 5.0% Professional Services Start 12 / 24 Construction Notice to Proceed 06 / 25 Substantial Completion of all Work 10 / 25 Professional Services Completed 11 / 25 RFQ date info : Electronic submittals should be combined into one PDF file named with the project number listed on the RFQ and your firm's name. Use the "print" feature of Adobe Acrobat Professional or similar software for creating a PDF rather than using a scanner. If possible, please reduce the file size of the PDF. In Adobe Acrobat Professional, go to Advanced, then PDF Optimizer. Also, please label the CD, DVD or USB Drive with the project number and firm name if applicable. The method of Contractor Selection has not been Determined at this time.