Renovation of an educational facility in Pearisburg, Virginia. Completed plans call for the renovation of a 650-square-foot educational facility.

Project Location: Macy Elementary I Middle School 1001 Henson Ave Pearisburg, VA 24134 o Before starting any work on the existing gym floor contractor shall generate a gym line(s) and center court graphic(s) layout drawing. The contractor shall submit line and center court graphic layout drawings to the owner for approval. Stain and paint colors forthe floor and all lines/ center court graphics shall be included in the drawing submission. Once the gym line and center court graphics drawing has been approved, then the contractor shall provide a stain and paint sample of actual approved colors applied on a sample wood board that matches the type and species of the existing gym floor. The sample will need to be approved by the owner before staining and painting lines/center court graphics on the gym floor. o The Contractor shall repair/replace the water-damaged gym floor section, subfloor, and any other work necessary to deliver a complete job. There is approximately 650 +/- s.f. of repair/replacement of the water-damaged gym floor (the contractor will need to verify the actual s.f. of the area to be repaired /replaced). Match the existing wood floor type and subfloor with the new material. The contractor will coordinate the area to be repaired/replaced with the owner before the start of work. The contractor will make sure that the area to be repaired/replaced moisture percentage in the slab I surrounding area is at a level of industry standards that will permit work to be done and to prevent warpage or defects. The contractor will remove damaged materials and dispose of them offsite. o Contractor shall remove all tape I foreign material on the remaining existing gym floor before sanding the floor in such a manner that no tape/residue is left on the existing floor before sanding. o Contractor shall sand existing gym floor to bare wood. All painted graphics/lines shall be removed. The existing and repaired gym floor shall be sanded to industry standards that will ensure a smooth and even surface ready to accept stain, sealer, line/center graphics and finish coats. o Contractor shall apply stain as per manufactures directions. o Contractor shall seal/apply 2 coats of 50 % high-solids VOC-450 oil-modified polyurethane finish. Afterthe first coat is fully dry contractor shall abrade the surface as per industry standards to make it ready to receive a second coat of sealer. Apply as per manufacturer instructions to prepare the surface for lines and center court graphic layout. o Contractor shall mark approved game lines and center court graphics layout with the use of a precision taping machine for circles and arches. Masking tape should be pulled as soon as the paint starts to set and not allowed to stand overnight. Paint should be allowed to dry for at least 12 hours. o After lines and center court graphics have dried to industry standards, abrade, and tack floor. Touch up any paint as necessary. Apply 2 even coats of 50 % high-solids VOC-450 oil-modified polyurethane finish with the grain; abrade, vacuum, and tack between coats. o Note for above work: Contractor will vacuum, clean, and tack the floor prior to moving on to the next step(s) as per industry standards. o The contractor will make sure that all of the gym is cleaned, free of sanding dust, contractor work equipment, trash (etc.), and ready for use after the job is completed.