Renovation of an educational facility in New York, New York. Completed plans call for the renovation of a educational facility.

College of Staten Island Buildings 1A & 2A Elevator Renovation Work located at College of Staten Island, 2800 Victory Boulevard, Buildings 1A and 2A, Staten Island, New York 10314 In accordance with State Finance Law 139-j and 139-k, this solicitation includes and imposes certain restrictions on communications between DASNY personnel and a prospective bidder during the procurement process. Designated staff for this solicitation is: Kevin Leavy, Project Manager, 2800 Victory Boulevard Building 3A, Room 3A-104, Staten Island, New York 10314, 518-322-2926, kleavy@dasny.org (the Owner's Representative) and DASNY at ccontracts@dasny.org. The work is estimated to be between $2,000,000 and $2,125,000. Work includes, but is not limited to, the following: Demolition: Removal of the existing elevator and equipment in exist. Elevator shaft. Rails to remain. Removal of the existing pump and controller in elevator machine room (emr). Removal of existing elevator call buttons, level indicators, and lanterns. See elevator drawings and specifications. Remove existing card readers. Scrape, sand & prep existing exterior elevator doors & frames at each landing which are to remain. Removal of fluid and water in existing pit. Removal of existing sump pump as shown on plumbing drawings. Remove existing emr doors, frames, and associated hardware. Remove light fixtures in emr. Remove portions of emr wall to accept new door. Remove concrete curb in bldg. 1a emr. See M.E.P. drawings and specifications for additional scope. Construction: Install new 3,500 lb. Capacity standard in-ground hydraulic passenger elevator and equipment to provide a complete replacement with exception of guide rails which are to re- main. See elevator drawings and specifications. Installation of new call buttons, level indicators, and lanterns. Installation of new elevator cab, interior doors, lighting, railings and all finishes. Installation of new card reader in new elevator cab. Patching and painting of walls at landings. Painting of existing exterior doors and frames at each elevator landing. Installation of new sump pump pit and new removable grate. New doors, frames, and associated hardware at emr. Patch walls of emr to accept to doors. Flash patch floor of emr as required. Install new epoxy floor with integral base in emrs. Install new lighting in emr. See M.E.P. drawings and specifications for additional scope. Install firestopping as required. Temporary Facilities and Controls: Temporary lights in the elevator pit and shaft. Temporary protection. *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document.