Site work and paving for a road / highway in Albany, New York. Completed plans call for site work for a road / highway; and for paving for a road / highway.

CR Number: 2126085 Sealed bids should not be sent or delivered to any other address or location, and the Authority is not responsible for any late deliveries or misdirected bids. For all technical or engineering related questions: o Beena Jain Project Designer Beena.Jain@thruway.ny.gov Or o Bob Cournoyer, P.E. Highway Design Bureau Director Robert.Cournoyer@thruway.ny.gov Or o Albert Mastroianni, P.E. Director, Office of Design Albert.Mastroianni@thruway.ny.gov Regardless of the delivery method selected, all sealed bids, whether paper or electronic form, must be delivered.Any bids sent or delivered to an address or location other than the one specified above, or received after this time, will not be accepted. 1R Mill and Inlay, Safety Improvements and Miscellaneous Work on I-90 between Milepost 148.2 and Milepost 154.3 in Albany County in accordance with the Plans and Specifications. Your bid must be secured with either a Bid Bond or a Bid Deposit. A Bid Bond must be in the amount of 5% of the total bid and must be on the Authority's Bid Bond Form (TA-44117) which is included in the Proposal. A Bid Deposit must be a certified check or cashier's check made payable to the New York State Thruway Authority in the amount of $750,000.00. The following is a general description of the work to be done under this Contract. This list is intended to give the Contractor a general description of the work involved in this Contract and is not a complete listing of all work to be done. All work shall be done in accordance with the Contract Documents even though not specifically mentioned in this list. 1. Provide basic work zone traffic control according to contract documents and as ordered by the Engineer. 2. Perform full and partial depth pavement repairs as indicated in the contract documents and as ordered by the Engineer. 3. Install guiderail/barrier and guiderail end treatments. 4. Perform 2-inch mill and inlay from MP 148.3_ to MP 154.04_, including shoulders, acceleration and deceleration lanes, U-turns, and specified Ramps at Interchanges 24 and 25. 5. Perform 2" mill and inlay to the fuel area at Guilderland Service Area. 6. Replace MIARDS removed by pavement resurfacing. 7. Perform localized tree trimming, drainage improvements, grading, and sign improvements. 8. Replace Overhead Sign Structures at MP 149.25, 149.81 and 153.96 9. Install permanent yellow and white highly reflectorized triple drop epoxy pavement striping in affected pavement areas, including recessed grinding for pavement markings. Install permanent yellow and white epoxy reflectorized pavement striping on specified ramps. 10. Restore disturbed areas and clean up as directed by the Engineer.