Site work and new construction of a pre-engineered storage facility in Richmond, Virginia. Completed plans call for the construction of a 1,200-square-foot pre-engineered storage facility; and for site work for a pre-engineered storage facility.

This project includes the full construction and installation of a 30' x 40' prefabricated metal garage structure on a monolithic turn-down slab foundation. Work includes site prep, foundation work, metal building erection, and final finishing. A. Site Preparation o Perform pre-construction site assessment and layout. o Clear and grub the area (vegetation, topsoil, debris). o Rough grade to ensure proper drainage and level pad. o Mark layout per engineered foundation plan. B. Excavation & Foundation - Turn-Down Slab o Excavate perimeter trench for turn-down edge (typically 12-24" deep x 12-18" wide). o Form and brace slab perimeter to exact dimensions (30' x 40'). o Install vapor barrier (minimum 6-mil poly sheeting). o Place and tie steel reinforcement: o Continuous rebar in trench footing. o Rebar or welded wire mesh throughout slab field. o Install anchor bolts or embedded plates to match metal building requirements. o Pour monolithic concrete slab (4"-6" thick center, with thickened edges). o Use 3,000-4,000 PSI concrete with fiber mesh (optional). o Trowel and finish surface (broom or smooth per client request). o Allow concrete to cure per industry standards (7-28 days before building installation). C. Metal Garage Building - Delivery & Erection o Receive and inventory prefabricated steel building kit. o Erect structural steel frame (columns, rafters, purlins, girts). o Install wall and roof panels using manufacturer-supplied fasteners and closures. o Use 26 or 29-gauge steel panels with matching trim. o Installing all required bracing, support members, and hardware. o Installing insulation (if included in scope). o Install exterior doors: o One overhead/roll-up door gable side (20'X14'). o One overhead/roll-up door side closes to parking lot (10'X10') o One or more walk-through (personal) doors. o Install ridge cap, eave trim, corner trim, and weather seals. D. Electrical (Optional) o Rough-in and install conduit, boxes, and wiring. o Install breaker panel, lighting, switches, receptacles, and door openers. o (4) outlets, (2) light switches, (4) 8' LED strip lights inside. o (3) LED Flood lights on outside. o Connect existing utility sources or run service to building from existing service in parking lot. o Coordinate electrical inspection. E. Final Work & Cleanup o Backfill around foundation as needed and final grade site. o Install concrete aprons approach. o Remove construction debris and perform full site cleanup. o Final client walkthrough and punch list correction. o Provide documentation: warranties, manuals, as-built drawings. 3. Inclusions o Engineering drawings for slab and building. o Concrete materials, forming, reinforcement, and finish work. o Delivery and installation of prefabricated metal building. o All labor, equipment, and supervision. o Permitting, architectural/engineering services. o Utility fees and tap/connection fees. o Landscaping, fencing, or paving beyond immediate building pad. o Rock excavation or soil remediation Question Deadline 09/12/2025 Suppliers must direct all inquiries to online, Contact with any other party may result in rejection of your bid. Period of Performance is 90 days from Receipt of Purchase Order.