Renovation of a multi-residential development in Rosharon, Texas. Completed plans call for the renovation of a one-story above grade, 16-unit multi-residential development.

The Texas Department of Criminal Justice (TDCJ) is requesting bids to establish a purchase order for the procurement of and installation of 16 shingle roofs for employee housing at the Memorial Unit. I. Statement of Work: a. All work performed must follow all Federal, State and Local laws and codes, guidelines, and standards. II. Project Overview: a. This scope of work outlines the requirements for the removal and replacement of the existing composition shingle roof and associated components. The contractor shall assess structural elements for damage, replace deteriorated materials, and ensure compliance with applicable building codes. Memorial Employee Housing Building numbers to receive roof replacement are as follows: i. Memorial - House #1188 - Four-plex ii. Memorial - House #1283 - Duplex iii. Memorial - House #1291 - Single iv. Memorial - House #1783 - Four-plex v. Memorial - House #1829 - Duplex vi. Memorial - House #2026 - Duplex and Garage vii. Memorial - House #2097 - Duplex and Garage viii. Memorial - House #2162 - Duplex ix. Memorial - House #2163 - Duplex x. Memorial - House #2164 - Duplex xi. Memorial - House #2165 - Duplex and Garage xii. Memorial - House #2457 - Duplex xiii. Memorial - House #2458 - Duplex xiv. Memorial - House #2501 - Duplex xv. Memorial - House #2649 - Duplex xvi. Memorial - House #2650 - Duplex xvii. Memorial - House #2651 - Duplex III. Demolition and Preparation: a. Remove and dispose of existing composition shingles, drip edge, and associated roofing materials. b. Assess and document the condition of fascia boards, rafters, soffits, vents, roof jacks, and decking. c. Remove and replace all deteriorated or damaged components as necessary. d. Remove inactive equipment to include satellite dishes to be identified by TDCJ Personnel. IV. Installation of New Roofing System: a. Install new composition shingles with appropriate ridge cap per manufacturer installation instructions. b. Apply new synthetic underlayment per manufacturer specifications. c. Install new D-style drip edge along all applicable roof perimeters (colors to be approved by TDCJ Personnel). d. Install and seal all new necessary roof vents, roof jacks, and flashing.