Renovation of an industrial development in Austin, Texas. Completed plans call for the renovation of a one-story above grade industrial development.

The Texas Workforce Commission (TWC) is accepting proposals to provide and install a heating, ventilation and air conditioning (HVAC) Energy Recovery Ventilator (ERV), ceiling tiles, flooring tiles, and perform duct work modifications at the TWC Mopac Building located at 12312 North MoPac Expressway, Austin, Texas 78758. Question Deadline 11/26/2025 at 5:00 PM CT Bid Portal A. Furnish all labor, materials, tools, equipment, and services required to integrate new packaged rooftop units installed as part of the scope of work of this project into the existing Niagara based Building Control System as indicated, in accordance with the Contract Documents (CDs). The existing control devices and accessories shall remain (wiring, devices and sensors per the CDs). Each new BCS component shall be compatible with and shall be fully integrated (i.e. point mapping and all graphics) into the existing Enterprise Server as outlined below. New components shall meet the specification requirements outlined in this specification section. 1. The basis of design is Distech Controls. 2. Alternate manufacturers shall only be considered if submitted for substitution prior to bid per Div. 1. 3. Do not base bids on unapproved manufacturers. B. Ensure and deliver the following features, hardware, and functions as a minimum and provide as required: 1. One Network Control Panel (NCP) for each major piece of equipment such as chillers, boilers, cooling towers, etc. 2. One Application Specific Controller (ASC) for each air-handling unit, packaged rooftop unit, make-up air unit, fan coil unit, etc. 3. Integration to third-party manufacturers' microprocessor controllers, as specified herein. 4. Furnish and install all sensors, transducers, and controlled devices per this specification. 5. Furnish all automatic control valves and control dampers for installation by the Mechanical Installer. Furnish and install all control damper and control valve actuators. 6. All monitoring, controlling, optimizing, interfacing, reporting, archiving, operator interface and information formulation and other special packages as required by the Contract Documents, including but not limited to the following: a. Scheduled stop/start. b. Optimum start/stop. c. Run time totalization. d. Duty cycling. e. Power demand control. f. Load restoration following a fire alarm. g. Automatic alarm lockout. h. Password access control. i. Graphics display. j. Dynamic graphical trending. k. Historical data recording and reporting.