Site work and renovation of a water / sewer project in Delta, Ohio. Completed plans call for the renovation of a water / sewer project.

The structure is a 600,000-gallon spheroid elevated water storage tank with a low-water level of 118.2 ft. located at 6671 County Rd. 10 in Delta, Ohio. The work includes: Exterior: Abrasive blast clean to a SSPC-SP6 commercial standard within containment. Apply a four (4) coat zinc epoxy urethane system. Wet Interior: Abrasive blast clean to a SSPC-SP10 near-white metal standard. Apply a three (3) coat zinc epoxy system. The cathodic protection system is to be removed and reinstalled by the Owners vendor (or approved equal), coordination and payment is the Contractor's responsibility. Dry Interior: Abrasive blast clean the entire tops of the platforms (including 1 ft. up the riser wall), the entire baseplate, and spot coating failures throughout to a SSPC-SP6 commercial standard. Apply a spot two (2) coat epoxy system to the prepared surfaces. Foundation: Repair grout. Abrasive blast clean and apply a two (2) coat epoxy system. Repairs: 1) Replace the access tube manway gasket. 2) Install a gasket on the wet interior roof hatch. 3) Install handholds at the roof hatches. 4) Install deflector bars on the fill draw pipe. 5) Replace the expansion joint. 6) Replace the mud valve. 7) Install a flap gate on the overflow discharge. 8) Replace roof vent with a pressure vacuum vent. 9) Install a seal at the access tube air gap. 10) Install a roof handrail with a painter's railing. 11) Replace the dry interior light bulbs. The Engineering Estimate for this project is $610,000. The structure is a 600,000-gallon spheroid elevated water storage tank with a low-water level of 118.2 ft. located at 6671 County Rd. 10 in Delta, Ohio. Exterior: Abrasive blast clean to a SSPC-SP6 commercial standard within containment. Apply a four (4) coat zinc epoxy urethane system. Wet Interior: Abrasive blast clean to a SSPC-SP10 near-white metal standard. Apply a three (3) coat zinc epoxy system. The cathodic protection system is to be removed and reinstalled by the Owner's vendor (or approved equal), coordination and payment is the Contractor's responsibility. Question Deadline 12/09/2025 The Bidder shall submit all questions about the meaning or intent of the Bidding Documents to DIXON in writing. Contact information and submittal procedures for such questions are to be made to the Issuing Office. 7.03 Interpretations or clarifications considered necessary by DIXON and in DIXON's sole judgement, in response to such questions will be issued by Addenda delivered to all registered plan holders. Questions received less than seven days prior to the date for opening of Bids may