Site work for a civil project in Edgewater, Maryland. Completed plans call for site work for a road / highway; and water / sewer project.

Description: This project, located in Anne Arundel County, is for the construction of eleven (11) sites in the County. The work will consist of the following: (a) Site 0202216.001: Installation of 24 in. RCP (12 ft.), manhole MD 328.01 (1 EA), headwall MD 360.01 (1 EA), Class I riprap stabilization apron (12 ft.), and stabilization of gully in embankment slope with Class II riprap as fill. (b) Site 0200575.001: Installation of Class I riprap channel/ditch, Class II riprap plunge pool, Class II riprap (incidental to plunge pool installation) (23 ft.), imbricated rock wall incidental to plunge pool installation (29 ft.), and stabilization of gully in embankment slope with fill. (c) Site 0201293.001: Installation of Class III riprap plunge pool and Class II riprap stabilization (incidental to plunge pool installation) (27 ft.). (d) Site 0200584.001: Installation of Class I riprap plunge pool, Class I riprap stabilization (Incidental to plunge pool installation) (44 ft.), 42 in. RCP (4 ft.) and endwall MD 358.01. (e) Site 0200586.001: Installation of Class I riprap stabilization at the outfall and Class I riprap channel (72 ft.). (f) Site 0200587.001: Installation of Class II riprap plunge pool and Class II riprap (incidental to plunge pool installation) (26 ft.). (g) Site 0291005.002: Installation of inlet MD 374.71 (1 EA), endwall MD 354.01 (1 EA), 18 in. RCP (8 ft.), Class I riprap stabilization apron (10 ft.), and reestablish embankment slopes with fill. (h) Site 0201748.001: Installation of headwall MD 352.02 (replacement for ex. end section), precast manhole MD 384.01, 24 in. RCP (21 ft.), Cured-In-Place-Pipe (CIPP) within ex. 24 in. CMP (93 ft.). Class I riprap apron and addition stabilization (19 ft.), and stabilization of gully in embankment slope with fill. (i) Site 0202836.001: Installation of 36 in. x 48 in. Conc. Box (10 ft.), endwalls (special design) (2 EA), Class II riprap stabilization apron (26 ft.), Class I riprap channel/ditch (58 ft.), reestablish embankment slopes with fill. (j) Site 0202842.001: Installation of 60 in. RCP (12 ft.), manhole MD 384.07 (1 EA), endwall MD 354.01 (1 EA), Class I plunge pool, Class I riprap (incidental to plunge pool installation) (31 ft.), and reestablish embankment slopes with fill. (k) Site 0201771.001: Installation of 18 in. RCP (74 ft.), manholes MD 384.01 (2 EA), headwall MD 352.01, and Class I riprap stabilization apron (20 ft.). Pre-Bid Conference: A Pre-Bid Conference has not been scheduled for this Project County: Anne Arundel Classification: E - $2,500,001 to $5,000,000 In accordance with State Finance and Procurement Title 13 of the Annotated Code of Maryland, no bid, performance or payment bonds are required for bids less than $100,000.00. However, bids $100,000.00 and above will not be considered unless a Bid Security is submitted as outlined in the Invitation for Bids. Bid Security shall equal at least five percent (5%) of the total amount bid. Also, the successful bidder will be required to supply Payment and Performance Bonds for all Contracts in excess of $100,000.00 The MDOT SHA reserves the right to reject any and all bids. MDDOT - 103 - Outfall Stabilization and Restoration at Various Locations in Anne Arundel County Written requests for information or questions shall be addressed to: Ryan Doheny, P.E. Acting Division Chief, Highway Hydraulics Division 707 North Calvert Street Baltimore, MD 21202-3601 or FAX to: (410) 209-5001 *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document.