Site work for a sidewalk / parking lot in Silver Springs, New York. Completed plans call for site work for a 53,000-square-foot sidewalk / parking lot.

The Wyoming County Department of Buildings & Grounds seeks a qualified contractor to provide labor and material for the resurfacing and striping of an estimated 53,000 square foot parking lot and driveway. The work includes providing all necessary labor, materials, tools, equipment, supervision, and other services required to mill, repair base materials, adjust grades, resurface, and stripe the specified parking lot. Contractors business/company must have at least 10 years' experience in lot maintenance, paving, and general site work. Agency submitting the Bid is the agency completing more than 75% of the work. Contractor must be registered with NYS to Qualify to bid Project is to be completed no later than September 25th 2026 All questions regarding the bid should be submitted in writing via email to Wyoming County Buildings and Grounds, Attention Michael Adamczak, by the deadline stated in the notice. Wyoming County reserves the right to reject or waive any and all bids/proposals and to waive any irregularities in procedure. Any questions regarding this advertisement to Bid should be submitted in writing (via email) to Wyoming County Buildings and Grounds, Attention Michael Adamczak, Madamczak@WyomingcountyNY.gov by May 20th, 2026 at 9:00 am Milling of all asphalt to the stone base, repair of base where necessary, compaction, installation of 2.5 inches of binder (min), 1.5 inches of top coat (min), and striping to pre-approved drawings. Wyoming County Dump Trucks/workforce to haul all milled materials from site, continuous rotation of four 10 wheelers hauling materials locally (Milling and sub base materials ONLY) o Besides County owned trucks for millings transport, all construction equipment and material are to be provided by the contractor Alterations of daily parking lot operations will take place during the timeline of the project o Note: construction needs to take place while maintaining multiple safe entry and exit points for public and employee foot traffic to and from the facility. Contractor to Repair any compromised or soft spots within the gravel base. Gravel base (clean) should be a minimum of 8 inches thick in all areas, and it is the duty of the contractor to ensure any non-gravel or "dirty" base material is removed adding and compacting new gravel to the proper grade. o Note: as base materials are unknown, please submit bid with allowances for providing and installing up to 100 ton of Crusher #2 gravel (or comparable). Any/all additional material to be proposed as a project change order. Asphalt Material Installation - Minimum of 2.5 inches of HOT asphalt binder w/ a minimum of 1.5 inches of HOT asphalt top coat. Asphalt is to transition to all sidewalks, roadways, drainage devices, etc. without possibility of trip hazards. Grade set so all water sheds towards DIs and/or away from lot. Ponding or stagnant water is not acceptable and will be properly fixed/repaired at the contractor's expense. All site/grade prep work and clean up are the responsibility of the Contractor. Contractor to paint approved parking spots, no parking zones, handicap spots, and fire lanes with appropriate dimensions and colors. (map/plan needs to be County approval prior to beginning) Any alteration to the work detail must be approved by the Buildings & Grounds Director. o Any changes or alterations outside of the contract must have approval via written consent/Change order - no exceptions