Renovation of a municipal facility in Edson, Alberta. Conceptual plans call for the renovation of a municipal facility.

The deliverables required are as follows: remove and properly dispose of existing roof top units (RTUs); install new devices with zoning capabilities; provide system testing, balancing, and commissioning upon completion. The objective of this project is to complete lifecycle replacement of three (3) RTUs with higher-efficiency units, where available (e.g., dual-fuel RTUs or advanced performance gas RTUs), to improve overall system performance and energy efficiency. The proponent shall be fully responsible for: all engineering required to complete the deliverables; preparation of drawings, specifications, and technical documentation stamped and sealed by a professional engineer licensed in the Province of Alberta; obtaining all required permits, approvals, and inspections from applicable authorities having jurisdiction; ensuring full compliance with all applicable codes, standards, bylaws, and regulations; coordination with Town staff, utilities, authorities having jurisdiction, and other stakeholders; testing, commissioning, and verification that the deliverables are fully operational and meet performance requirements. All equipment installed shall comply with the structural roof loading requirements as determined by the buildings structural design. Under no circumstances shall installed units exceed the allowable roof load capacity. The contractor shall verify and ensure compliance prior to installation. If you have questions, please contact the Contact Person below only by email. Contact Person Jackie Elliott Capital Projects Coordinator - Facilitie Method of Contact jackiee@edson.ca Address PO Box 6300 605-50 Street Edson, Alberta Canada T7E 1T7 Questions must be submitted by email no later than - Jun 12, 2026 at 11:59 pm (MT) The method of Contractor Selection has not been Determined at this time.