Renovation of an industrial development in Kingston, Idaho. Completed plans call for the renovation of a industrial development.

Question Deadline 07/20/2026 at 12:00 PM PT Questions pertaining to this RFQ must be submitted in writing by email to mrsande@idl.idaho.gov Quotes are requested for roof and siding replacement for a metal storage building at the Cataldo Forest Protection District. All price quotes must be entered on the attached Schedule A and electronically submitted to the specified email. The contract will be awarded to the qualified vendor with the lowest responsible and responsive quote, based on the total price in U.S. dollars. Vendors are encouraged to attend an optional pre-bid site visit to verify measurements. Quotes must be received before the specified deadline via email; late, faxed, or mailed quotes will not be accepted. Project shall include the demolition, removal and disposal of existing metal roofing, siding, and associated trim on 125' x 30' metal building. The existing siding, roof, and trim will be replaced with 24-gauge Glacier White Purlin Bearing Rib (PBR) roofing, Ivory colored 26-gauge high tensile steel siding, associated trim to include ridge cap, drip cap, corner caps, beam and door wraps. Additionally, vendor will install 2" insulation blanket on enclosed portion of the building (approximately 50'x30' exterior dimension), approximately 50' of rain gutters, 4 downspouts, 100' of snow breaks as directed by the COR, and an owner provided exterior light (owner provided exterior light will replace existing exterior light). Roof and siding fasteners must be #14 minimum size. Minimum 7-year warranty on materials and workmanship. Contractor to provide any and all necessary permits. All bids over $50,000 must include a copy of the vendor's public works license for the State of Idaho submitted with the Schedule A. Note: 1. Exterior dimension of the building is approximately 125' x 30'. 2. Roof pitch is approximately 3:12. 3. Eve of building is approximately 11' above ground level. 4. Peak of building is approximately 13'6" above ground level. 5. Existing sliding door and awning on west side of building will be removed by the owner and metal siding installed in its place PROJECT REQUIREMENTS: 1. Contractor will ensure they meet any and all State trade licensing requirements. All work to be completed will meet all applicable State and Federal laws. 2. Contractor shall be responsible for all permits and permit fees. 3. Contractor will remove and dispose of existing materials that are to be replaced. 4. Contractor will provide new materials unless specifically stated that the owner will provide materials to be installed. 5. All materials must be installed in accordance with manufacturer's specifications. 6. Contractor is responsible for verifying the accuracy of all measurements. 7. Contractor will protect building and landscape and leave the premises in a clean and debris free condition. SAFETY: Contractor shall comply with all applicable local, state, and federal safety regulations including: - Federal Occupational Safety and Health Administration (OSHA) Standards. - The Contractor will be solely responsible for safety at the site.