Renovation of an educational facility in Binghamton, New York. Completed plans call for the renovation of a educational facility.

Any questions or request for clarification regarding the information provided may be directed to the project manager listed on the request for quote sheet or via email at brm.bids@opwdd.ny.gov SCOPE OF WORK: 1 . Existing Concrete within the marked area shall be removed, as well as all tree stumps and root sections. In their entireties. 2. Areas marked grass and concrete on the sketch . See detail below. Existing drain locations must be maintained. 234 New cast drain inlet terminations to be installed flush with new grade. Connections to the existing pipe shall be made with a fully banded connector (standard "Fernco" type fittings are not acceptable). The new inlets should be of sufficient construction to withstand commercial mowing equipment. (Submittal approval required). New sidewalks shall be 5000psi air entrained concrete 4" thick with 6x6 - w2.9xw2.9 wwf (placed & held mid slab by use of 2" reinforcement spacers). Subgrade shall be compacted with 8" minimum compacted subbase Course A1 Aggregate. See detail below. Substrate shall be compacted in no more than 4" lifts. Walkways must rise/slope to be flush with the doors threshold at each exit. Do not exceed ADA allowable slope of 1:12 ratio or 8.33%. Walkways should have a cross slope of 2% away from the building. Underpin doorways a depth of 6" into the floor slab and install #4 rebar 12" apart under doorways beginning & ending 10" outside of every doorway +/-. Rebar shall extend 3' into the sidewalk slab. 10. Slabs size should be limited to, no larger than 6'x8' . Expansion joints: 1/2 " material shall be placed between perpendicular joints, and along the building edges, and every 50' of linear run. 11. Control joints shall be spaced every 6' +/- of linear walkway. 12. Edges shall be troweled with a brush finish on walking surface. 13. Sidewalk shall be sealed with waterproof mastic at building edges and expansion joints. Minimum thickness of 1/2" and good adhesion to both surfaces. 14. Soil grade at the edge(s) shall be level for a minimum of 16" before falling into existing grade. 15. All areas restored to grass shall have a minimum depth of 4" of clean topsoil lightly compacted. 16. Contractor shall generously spread contractor grade grass seed , rake in and cover it with straw and water. The facility will water after it is put down. 17. Contractor shall warrantee work for a period of one year from date of payment for job. Warrantee shall be for parts and labor. 18. Work shall conform to all applicable codes, be done according to manufacturers' instructions, and follow industry best practices.