Outdoor lighting for a municipal facility in Allen, Texas. Completed plans call for outdoor lighting for a municipal facility.

Replacement of aged out or downed streetlights throughout the community. The City desires the replacement of several downed streetlights within the community. In the table below are the locations and technical specifications for the desired replacement equipment. The bidder will be responsible for acquiring the specified equipment, the installation of said equipment, removal of specified foundations that are not reusable, and submitting required Traffic Control Plans for approval via the Right-Of-Way (ROW) permit application. Bidder is to coordinate with City or power company and acquire necessary permits, as needed , to make successful connection of new streetlight to existing power. Electrical work must be completed by a licensed electrician. Bidders are to bid on all locations. The City reserves the right to pick-and-choose any combination for the below outlined streetlight replacement locations. The following general streetlight attributes ( as outlined in the Allen Land Development Code Sec. 8.11) shall be incorporated into the bid. Additionally, the City Streetlight Standard Details have also been included for consideration. Submitted streetlight bids must conform to both. All thoroughfare lighting poles shall have the following attributes: Thirty-foot height. Installation location shall be in the median. Dual fixtures installed, if located in the median. Single fixtures are acceptable in situations that require parkway installation or the median width makes the installation of dual fixtures impractical. Capable of withstanding a 100 mph wind, with 30 percent gust factor. Mounted on a cast-in -place pole- base, as illustrated in the Engineering Standard Details, using a 14- inch bolt pattern for the anchor bolts. Mounting bolts shall be a breakaway type bolt. For SQUARE CITY STANDARD pole type: Powder-coated medium bronze, seven-inch x seven-inch, and straight (for shoebox fixtures). Square, steel base cover, powder-coated or galvanized to match the finish of the pole. See City streetlight details for more information. For ROUND TAPERED pole type: Galvanized finish, round tapered steel shaft, 11 gauge with 5-1/8" Square conduit opening; 30-ft tall Follow foundation details outlined above, in City Streetlight Details SD-SL01 and SD-SL03. Where otherwise not stated, Bidder is to match existing dimensions, color, and fit and finish of adjacent round tapered poles in the vicinity All thoroughfare fixtures shall have the following attributes: Light emitting diode (LED) lamps, 250-watt equivalent. LEDs shall be a color of 3000K. If existing bulbs in reused fixtures do not comply, they are to be replaced. The use of cut-off optics is required to achieve a fully shielded (as defined in articles of this Code) light source. This requirement shall not be modified. For shoebox installation, the fixture shall be powder-coated medium bronze and shall be Trastar Duralight JXM -ST Shoebox or approved equivalent. In the case of cobra-head installation, finish shall be grey and shall be GE Evolve Series or equivalent. Question Deadline 10/12/2026 at 2:00 PM CT All questions regarding bid/proposal preparation, selection process, specifications and interpretations of the terms and conditions of the bid/proposal shall be submitted in writing. Any addenda will be issued no later than seven -two (72) hours prior to the deadline for submission of bids.