Renovation of a military facility in Wichita, Kansas. Completed plans call for the renovation of a military facility.

SCOPE OF WORK BY TRADE PACKAGE (PRICE EACH PACKAGE) The work covered in this contract consists of furnishing all labor, expertise, equipment, materials , facilities, transportation, and appliances necessary to perform operations in connection with the work described in paragraph SW-3 . It is the intent of the government for the contractor to provide a complete and useable system. Any relevant details required for a complete system that are omitted in the contract plans and specifications will be provided by the Contractor at no cost to the government. GEOTHERMAL HEAT PUMP UNIT (EQUIPMENT SUPPLIER) - 0001.01 New 4-ton geothermal (water-source) heat pump to replace existing ClimateMaster TEH049 (460V/3ph), matched to existing loop and electrical, with vibrati HVAC MECHANICAL (REMOVE/INSTALL/COMMISSION, DISPOSAL, DDC SUPPORT) - 0001.04 Remove existing unit: isolate/drain geothermal loop, recover refrigerant, disconnect electrical/condensate/DDC, rig unit down through ceiling - 0001.05 Off-base disposal of existing unit with two tipping tickets and prime cover letter (SOW 1.2.b, SW-12) - 0001.06 Install new unit in same location: hang/support, loop supply/return with isolation valves and flex connectors, condensate trap, vibration isolation - 0001.08 Loop commissioning: flush/purge loop, EWT/LWT, refrigerant charge, airflow and delta-T, calibrate (SOW 1.3.c) - 0001.10 DDC coordination and verification: schedule/support Sandifer, confirm with CE that unit reports and controls before turnover ACOUSTICAL CEILING (GRID REMOVE/STORE/REINSTALL) - 0001.02 Ceiling grid removal in Room 141 (12-ft ceiling) and protected storage for reinstallation (SOW 1.1.b) - 0001.11 Ceiling grid reinstallation using stored materials, replace tile damaged in removal LIFT RENTAL (EQUIPMENT) - 0001.03 Lift rental and mobilization, small lift for work above 12-ft ceiling (~400 lb unit) ELECTRICAL - 0001.07 Electrical disconnect and reconnect: verify existing circuit/disconnect vs new nameplate, terminate, ground, test DDC CONTROLS PROGRAMMING (SANDIFER ENGINEERING, SOLE SOURCE) - 0001.09 DDC programming by Sandifer Engineering (KANG's DDC programmer, SOW 3.b.i): point mapping, sequence, graphics, verification