Site work for a municipal facility in Burgess Junction, Wyoming. Completed plans call for site work for a municipal facility.

Generator Replacement Burgess Junction, Wyoming -- This project consists of replacing the generator in the main shop to include; removal & disposal of existing 80kw generator, purchase and installation of a new 100kw generator including all connections necessary; electrical, propane, exhaust and mounting hardware. Ensure compliance with NEC, state, and local electrical codes Location; 9864 US HWY 14A Questions concerning this bid should be posted to Online. WY DOT - Generator Replacement Contacts District 4 Facilities Manager- Kirby Goodvin (307) 752-8170 Burgess Jct. Crew Leader- Ryan Colby (307)763-1864 Generac Industrial gaseous 9.0L V-8 engine-driven generator, consisting of the following features and accessories: Stationary Emergency-Standby rated 100 kW Rating, wired for 120/208 VAC three phase, 60 Hz Brushless Excitation LP Vapor fuel system Level 2 Acoustic Enclosure, Steel Industrial Grey Baked -On Powder Coat Finish o UL2200 EPA Certified SCAQMD o H-100 Control Panel o Meets NFPA 99 and 110 requirements o Temp Range -40 to 70 degrees C Digital Microprocessor: Two 4-line x 20 displays, full system status 3 Phase sensing, +/-0.25% digital voltage regulation RS232, RS485 and Canbus remote ports Waterproof connections All engine sensors are 4-20ma for minimal interference Programmable I/O Built-in PLC for special applications Engine function monitoring and control: Full range standby operation; programmable auto crank, Emergency Stop, Auto-Off-Manual switch Isochronous Governor, +/-0.25% frequency regulation Full system status on all AC output and engine function parameters Service reminders, trending, fault history (alarm log) 12T function for full generator protection Selectable low-speed exercise 2-wire start controls for any 2-wire transfer switch 21 Light Annunciator - Surface Remote Emergency Stop Switch, surface-mount, shipped loose Battery Heating Pad 90 AH, 700 CCA Group 27F Battery, with rack, installed Coolant Heater, 1500W, 120VAC 1 Hour factory load test at reactive (0.8) power factor all work is not completed by March 31 , 2027.