Renovation of a mixed-use development in Friendsville, Tennessee. Completed plans call for the renovation of a 460-square-foot educational facility.

**As of November 29, 2023, this project has not yet been awarded. A timeline for award has not yet been established.** Question Deadline 10/30/2023 Bidders shall submit questions about bidding documents to Designer in writing. Replies will be issued to Bidders of Record by addenda and will become part of Contract Documents. Designer and Owner will not make oral clarifications. Questions shall be received by Designer at least six calendar days before bid opening date. Replace decorative fountain at Pellissippi State Community College, Blount County Campus, Friendsville, Tennessee. Remove existing planters adjacent to the fountain. A. Furnish all labor, materials and equipment, and perform all work to construct, as specified herein and as shown on the accompanying drawings entitled "A Renovation for Pellissippi State, Blount Campus, Water Fountain Replacement, 2731 W. Lamar Alexander Pkwy. Friendsville, TN 37737." The water fountain shall be constructed complete and ready for operation except for the items specifically excluded in "Work Not Included". B. The work shall include; selective demolition, site preparation, concrete, pavers, and site improvements as shown and specified. C. Patch any existing work damaged by construction. 1.02 VERIFICATION OF DIMENSIONS: A. Dimensions, elevations, and locations shown on the drawings in reference to existing structures and utilities are the best available data obtainable but are not guaranteed by the Architect or the Owner and the Architect and the Owner will not be responsible for their accuracy. B. Before proceeding with any work dependent upon the data involved, the Contractor shall field check and verify all dimensions, grades, line levels, or other conditions of limitations at the site and building to avoid construction errors. If any work is performed by the Contractor or by his Subcontractors prior to adequate verification of applicable data, any resultant extra cost for adjustment of work to conform to existing limitations shall be borne by the Contractor without reimbursement or compensation by the Owner. 1.03 CONTROL POINTS AND LAYOUT: A. The initial lines, grades, and dimensions necessary for the location and control of the work under the Contract are shown on the Contract Drawings. B. The Contractor shall provide for himself all additional and supplementary lines and grades as may be necessary to layout the work and insure proper control of the work until completed. It shall be the Contractor's responsibility to satisfy himself as to the accuracy of all measurements before construction.