Renovation of a mixed-use development in Portage, Michigan. Completed plans call for the renovation of a 1,334-square-foot educational facility.

Remodeling consisting of replacement of Service Center boiler, replacement of West Campus boiler, and replacement of Woods Edge Learning Center Air-Cooled Chiller and Boiler. Questions should be directed to Stan Hoekstra (stan.hoekstra@kresa.org) at KRESA, and Perry Hausman (phausman@towerpinkster.com) at TowerPinkster. The last day for questions is 4 PM on January 15, 2021. Bidders will be required to provide Bid security in the form of a surety bond, certified check, or cashier's check in the amount of 5 percent of the bid amount. Performance and Payment bonds will be required. No bids may be withdrawn for a period of 30 days after submission. Owner reserves the right to accept or reject alternates for a period of 45 days after bid opening. The Owner reserves the right to accept or reject any or all bids, alternates, or proposals, and to accept those bids, alternates, or proposals that, in his judgement, serve his best interests. Project Identification: Replacement of Service Center boiler and pump, replacement of West Campus boiler, and replacement of Woods Edge Learning Center Air-Cooled Chiller and Boiler. 1. Project Locations: Service Center West 1819 E Milham Avenue Portage, Michigan 49002 Campus Woods 4606 Croyden Avenue Kalamazoo, Michigan 49006 Edge Learning Center 1501 E. Milham Avenue Portage, Michigan 49002 The scope of work is to include but not be limited to the following: 1. Obtain all required electrical construction permits and inspections. 2. . 3. Provide a 277/480 volt, 3 phase, 4 wire, distribution system for HVAC equipment. 4. Provide a 120/208 volt, 3 phase, 4 wire, distribution system for HVAC equipment, convenience receptacles, small appliances and small motors. 5. Refer to mechanical drawings, security, communications and access control drawings. Provide low voltage raceways (1/2" minimum) for all thermostats, controls and low voltage systems. No low voltage wiring of any type shall be visible in exposed ceiling areas. 6. Provide complete electrical installation including all components, i.e. receptacles, conduit, wire, etc. 7. Provide raceway system for telephone/data networking systems. 8. Provide for Owner training by factory representatives in operation and maintenance of systems where specified. 9. Provide selective demolition of electrical systems and equipment as indicated on the drawings. 10. Submit documentation such as shop drawings, record documents, maintenance manuals, infrared scan results, systems test results, fire alarm system certification, etc. as specified.