Renovation of a water / sewer project in Richmond, Texas. Completed plans call for the renovation of a water / sewer project.

All questions shall be submitted at www.civcastusa.com through the question and answer section. Questions will not be answered after 12:00 P.M., two (2) calendar days prior to bidding. The work includes, but it is not limited to, demolish the existing motor control center, power factor correction capacitors; relocate the existing booster pump VFD, pneumatic control panel, control panel, chart recorder, autodialer; install a new 600A NEMA 1 motor control center for all loads at the plant; install a new CMU MCC building including all associated electrical and mechanical; blast and recoat the interior and exterior of GST No. 1; replace GST No. 1 roof air vents; replace GST No. 1 interior ladder; replace GST No. 1 manway davit arm; clean and touch-up coat GST No. 2 foundation flange; clean and touch-up HPT No. 1 saddles and piping, install a digital pressure gauge, replace cabinet light; clean and touch-up HPT No. 2 saddles, install digital pressure gauge, lower existing pressure gauge; clean and touch-up Remote Water Well No. 1 motor, discharge piping, and air release valve. The bidder shall submit a certified or cashiers check on a responsible bank in the State of Texas to two percent (2%) or a five percent bid bond of the minimum total bid amount. Make the cashiers check or the bid bond payable to the Owner.The disclosure of interested parties form shall be completed and included with the sealed bid at the time of the bid opening.The requirements of Subchapter J, Chapter 552, government Code, may apply to this Bid/Contract and the Contractor agrees that the Contract can be terminated if the Contractor knowingly or intentionally fails to comply with a requirement of that subchapter. The Owner reserves the right to reject any or all bids and waive any or all irregularities. No bid may be withdrawn until the expiration of sixty (60)days from the date bids are open.