Renovation of a military facility in Plymouth, New Hampshire. Working plans call for the renovation of a military facility.

As of July 9, 2021, this project ahs been cancelled. No further information available at this time. Location 19 Armory Road, Plymouth, NH Vendor shall supply all labor, tools, transportation, materials, equipment and permits as necessary and required to perform services as described herein. Except as otherwise provided in this Scope of Services, all services performed under any contract resulting from this solicitation shall be performed between the hours of 7:30 A.M. and 4:00 P.M. unless other arrangements are made in advance with the State. Any deviation in work hours shall be pre-approved by the Contracting Officer. The State requires ten-day advance knowledge of said work schedules to provide security and access to respective work areas. No premium charges shall be paid for any off-hour work. The Vendor shall not commence work until a conference is held with each State agency intending to utilize the Vendor's services, at which representatives of the Vendor and the State are present. The conference shall be arranged by the State agency. The State shall require correction of any defective work and the repair of any damage to any part of a building or its appurtenances caused by the Vendor or its employees, subcontractors, equipment or supplies. The Vendor shall correct, repair, or replace all defective work, as needed, to complete said work in satisfactory condition, and the Vendor shall repair all damage so caused in order to restore the building and its appurtenances to their previous condition. Upon failure of the Vendor to proceed promptly with the necessary corrections or repairs, the State may withhold any amount necessary to correct all defective work or repair all damage from payments to the Vendor. o Demo and dispose of three sets of outside doors and frames o Prep areas so that doors are sealed and properly secured in place when installed. o Install Front entry double doors with glass with frame and new hardware for control access door. o Install rear entry double doors with frame and new hardware for a control access door. o Install rear entry double door with frame and new hardware non control access door. o Install three new thresholds at each set of double doors. o All sets of doors are properly replaced and functional prior to the job being complete