Site work for a water / sewer project in Kenton, Tennessee. Completed plans call for site work for a water / sewer project.

The owner reserves the right to waive any informality or to reject any or all bids. Each bidder must deposit with his bid, security in the amount, form ands ubject to the conditions provided in the Information for Bidders. The Project consists of the repair and rehabilitation of sanitary sewer infrastructure as described in the drawings and project manual. Electronic files may be downloaded freeof charge from the A2H Planroom at www.a2hplanroom.com. Hardcopysetsofplansandspecifications will also available forpurchase on the planroom at the contractor'sexpense. This work consists of the method and process for furnishing all labor, materials, tools, equipment, and incidentals, necessary to provide for the complete rehabilitation of deteriorated sanitary sewer pipes by forming a new tight-fitting liner within the existing pipe. The process in a typical and general form consists of a flexible felt tube impregnated with an approved resin, which is inserted into an existing pipe. The curing may be accomplished by circulating heated water or air, curing resin system to affect the desired cure throughout the length of the tube, extending full-length from manhole to manhole. The resin should be cured into a hard, impermeable pipe of the desired thickness, providing a structurally sound, smooth interior and tight-fitting liner within the existing pipe. The lined pipe shall provide a hydraulic flow almost equal to, or greater than, the original new sewer capacity. Scope of construction work is shown on drawings and specified in other sections. Civil: sewer manhole repairs, sewer manhole lining, 8 in. and 15 in. gravity sewer installation, cured in place pipe installation, heavy cleaning of existing gravity sewer, and point repairs of existing gravity sewer. Notice: In no event is a product to be used in this project known to contain any hazardous or toxic waste or material, radioactive materials, or other contaminants, the removal of which is required or the maintenance of which is prohibited, regulated or penalized by any local, state, or federal agency, authority or governmental unit. If any product is inadvertently specified which contains such materials, it is the Contractor's, subcontractor's and supplier's obligation and duty to advise the Architect/Engineer of this fact prior to the ordering and/or installing of the product or material. General Explanation: A substantial amount of specification language constitutes definitions for terms found in other contract documents, including the drawings which must be recognized as diagrammatic in nature and not completely descriptive of requirements indicated thereon. Certain terms used in the contract documents are defined generally in this article. Definitions and explanations of this section are not necessarily either complete or exclusive, but are general for the work to extents not stated more explicitly in another provisions of the contract documents. This section supplements the definitions contained in the General Conditions. General Requirements: The provisions or requirements of Division 01 sections. General requirements apply to either work of contract and, where so indicated, to other elements of work which are included in the project. Other definitions are included in individual specification sections. Other definitions are included in individual specification sections.