Site work for a civil project in Pblo of Acoma, New Mexico. Completed plans call for site work for a water / sewer project.

Pueblo of Acoma (Owner), thru Pueblo of Acoma Utility Authority (POAUA Owner's Representative) is requesting Bids for the construction of the following Project: Acoma Public Water System & Water Storage Tank Improvements, IHS Project AL-14-A05 & AL-04-208 The Project consists of constructing approximately 2,121 LF of 6-inch PVC water main; 4,612 LF of 10-inch PVC water main; 6,008 LF of 12-inch PVC Water Main; 120 LF of bore and jack w/20-inch Steel Casing for 10-inch PVC water main; 350 LF of horizontal directional drilling for 10-inch HDPE; 100 LF of horizontal directional drilling for 12-inch HDPE; Installation of submersible pump, motor, and approximately 693 LF of 4-inch drop pipe at Anzac Well No. 7; as well as, construction of 350,000-gallon McCarty's water storage tank and concrete flow valve vault. Obtaining the Bidding Documents Prospective bidders may obtain a copy of the Bidding Documents from the POAUA via e-mail at no cost, Monday through Friday between the hours of 9 am to 4 pm, from the Issuing Office as described below. Partial sets of Bidding Documents will not be available from the Issuing Office. Neither Owner nor Engineer will be responsible for full or partial sets of Bidding Documents, including addenda, if any, obtained from sources other than the Issuing Office. Requests for Bidding Documents can be sent to aseymourjr@poamail.org. The documents listed above are to be submitted by 12pm September 27th, 2021. For all further requirements regarding bid submittal, qualifications, procedures, and contract award, refer to the Instructions to Bidders that are included in the Bidding Documents. 1-60809 The Project consists of constructing approximately 2,121 LF of 6-inch PVC water main; 4,612 LF of 10-inch PVC water main; 6,008 LF of 12-inch PVC Water Main; 120 LF of bore and jack w/20-inch Steel Casing for 10-inch PVC water main; 350 LF of horizontal directional drilling for 10-inch HDPE; 100 LF of horizontal directional drilling for 12-inch HDPE; Installation of submersible pump, motor, and approximately 693 LF of 4-inch drop pipe at Anzac Well No. 7; as well as, construction of 350,000-gallon McCarty's water storage tank and concrete flow valve vault.