Renovation of an educational facility in Saint Paul, Minnesota. Completed plans call for the renovation of a educational facility.

Construction Services for replacement of the MRI in the Veterinary Medicine Center, located on the St. Paul campus. Refer to the Request for Proposal documents (found in the Attachments tab) for full project details/requirements. Before submitting questions about the RFP via the Questions Tab, read and review the RFX INSTRUCTIONS, REQUIREMENTS, AND RIGHTS RESERVED BY THE UNIVERSITY DOCUMENT and ALL Attributes in the Attributes Tab. These provide valuable information and address frequently asked questions. The total construction budget for this Project is $445,831 The University requires the Project to be substantially complete by no later than January 31, 2022. Deadline for RFP Questions October 7, 2021 at Noon Background The Board of Regents of the University of Minnesota (the "University") is requesting Proposals to provide construction services for replacement of the MRI in the Veterinary Medicine Center, located on the St. Paul campus (the "Project"). Project Description The scope of the Project includes installation of a new MRI in the Veterinary Medicine Center. Refer to the attached RFP Documents for full Project details. HGA Architects is the Architect/Engineer of Record for the Project The following goals and requirements apply for this Project: o Participation of Targeted Businesses equal to or greater than thirteen percent (13%) of the Base Bid/Proposal costs. o No less than 75% of the work or material contracted to the identified TGB enterprise(s) must be performed or supplied by said TGB enterprise(s). Workforce Utilization Requirements Workforce levels of participation (based on goals set by the MN Department of Human Rights) for the Project are: o 32% Minority Employees; o 20% Female Employees; o 2% Disabled Employees. PROJECT INFORMATION Site Location: 1352 Boyd Avenue, St. Paul, MN 55108 Project Summary: Alteration of _an existing MRI scanning room to remove and replace the magnet and associated equipment. Magnet replacement will occur through existing knockout panels in walls and reconstructed after the new magnet has been installed. Associated equipment includes vendor equipment in the adjacent equipment room with overhead connections into the scanning room and rooftop equipment serving the space