Renovation of a parking garage in Clifton Park, New York. Completed plans call for the renovation of a parking garage.

The proposed project will consist of furnishing all materials, equipment and labor necessary for the installation of an awning roof structure at the Town of Clifton Park Highway Garage off of Clifton Park Center Road 1. A building permit will be required for this work and must be obtained by the Contractor through the Town of Clifton Park Building Department. Provide the plans included in the Contract Documents to the Town of Clifton Park Building Department when applying for the building permit. 2. Provide all necessary survey, stakeout, and layout required to construct the work of this Contract. 3. Contractor shall layout truss configuration in field prior to ordering. Advise Engineer of any conflicts found with existing building exterior or existing building eaves should any such conflicts be identified. 4. Provide maintenance and protection of traffic. 5. Furnish and install temporary erosion and dust control methods throughout the duration of the project as necessary to protect the environment and to limit disturbances caused by work of this Contract. 6. Furnish all materials necessary, and install new awning roofing system including all excavation, foundation footings, rebar, backfill, wooden columns, steel girder beams, roof trusses, sheathing, ice underlayment, metal roof panels, soffit, and fascia, as shown and specified. 7. Furnish and install flashing between existing wall and proposed awning roof structure to provide a single watertight roof, as shown and specified. 8. Furnish and install bird screen underneath trusses and on sides of end trusses, as shown and specified. 9. Furnish and install light fixtures, including all conduit, conduit supports, wire, light switch, circuit breaker in existing power panel, and all required penetrations as shown and specified. 10. Contractor is responsible for relocation of any existing exterior building items that create a conflict with the new awning, including but not limited to, light fixtures and vent piping. Any vent piping to be relocated shall be routed up through the awning roof and sealed and flashed per the metal roof panel manufacturer's recommendations. 11. Clean up and dispose of all debris resulting from this contract in a legal manner. 12. Coordinate all work with Town Highway Department operations to limit disruption caused by work under this contract. 3. Restore all areas disturbed by this contract to the Owners satisfaction and as specified herein. 14. Provide temporary facilities as required to perform work under this contract. 15. Provide protection of persons and property from hazards associated with this work. 16. Provide quality control testing required for materials incorporated into this project