This is a service / maintenance or supply contract in Brandon, Manitoba. Contact the soliciting agency for additional information.

Reference Number 0000214224 Source ID PP.CO.MB.557691.C81307 Purchase Type Term: 2022/03/09 12:00:00 AM CST - 2022/09/30 12:00:00 AM CDT Bid Intent Not Available Question Acceptance Deadline 2022/01/07 04:00:00 PM CST The Work includes all that is required for the In-Line Inspection Smart Pigging of sweet natural gas pipeline, NPS 6 Brandon Pipeline, approximately 21 km in length near Brandon, Manitoba. 1.2 Descriptions of ITEMS of the Work listed below are provided as a general overview. The detailed Purchasers Requirements are provided in the Technical Requirements. 1.3 The Work may include, but is not limited to, the following ITEMs for each pipeline project: 1.4 ITEM 1 Job preparation visit. Includes reviewing project schedule and logistics to align with Purchaser and In-Line Inspection Services Contractor. 1.5 ITEM 2 Mobilization. Travel from home base to job site and site work. 1.6 ITEM 3 Geometry tool inspection or at least equivalent. Includes all required geometry tool inspection reporting and above ground tracking and smart pig tracking. 1.7 ITEM 4 Magnetic flux leakage tool inspection or at least equivalent. Includes all required magnetic flux leakage tool inspection reporting and above ground tracking. 1.8 ITEM 5 Demobilization. 1.9 Additional Information: (a) Preliminary and final reports are required and shall be included as part of the Work, this requirement is detailed in the Technical Requirements. (b) The geometry tool inspection or at least inspection in ITEM 3 and magnetic flux leakage tool or at least equivalent inspection in ITEM 4 may be combined into a train as a single run. This determination is the responsibility of the Contractor. (c) The Contractor shall comply with Section 9 INCOMPLETE OR LOSS OF INSPECTION DATA PENALTIES of the Technical Requirements regarding incomplete inspection data and payment. For more information contact: Kelley Craig, Buyer Supply Chain Management Procurement Dept. 360 Portage Avenue (2) Winnipeg MB R3C 0G8 Email: kcraig@hydro.mb.ca Details a) Adherence to Technical Requirements: Proposed tools shall meet the minimum detection and measurement requirements specified in ITEM 3 and ITEM 4 of the Technical Requirements b) Capabilities and Limitations of Tool - All in-line tools shall be capable of navigating the specified pipeline system and features. c) Ability to meet the Preliminary Report deadline with a tolerance of 1 week. Official bid documents must be obtained from Merx and bid submissions must be done through the Merx platform.