Renovation of a municipal facility in West Ossipee, New Hampshire. Completed plans call for the renovation of a municipal facility.

Please Direct Any Questions Regarding This Bid to Kimberly Hanson: E-mail Kimberly.d.hanson1@das.nh.gov Email Your Bid to: Nh.purchasing@das.nh.gov. 04/13/2022. Last day for questions, clarifications, and/or requested changes to bid The State reserves the right to reject any or all bids or any part thereof and add/delete items/locations to the contract. Vendor shall supply all labor, tools, transportation, materials, equipment and permits as necessary and required to perform services as described herein. Whittier Mountain o Replacement of (1) Marvair Unit o Isolate the power to one unit at a time and make safe for disconnect. o Disconnect electrical and control wiring. o Recover old R-22 refrigerant from unit and recycle properly. o Disconnect supply and return grills from inside shelter. o Remove old existing unit and dispose of properly. o Safely lift new unit into original location. o Reconnect electrical and control wiring. o Reinstall supply and return grills on unit. o Install and wire new Comm Stat 4 lead/Lag Controller. o Perform a thorough start up and check out of unit. o Obtain any necessary permits and/or inspections. Oak Hill and Holden Hill (At each location): o Remove existing DOS indoor/outdoor split heat/air conditioner systems per EPA regulations from the Communications Shelter. DESC Radio personnel will transport old equipment off site. o Remove and dispose of existing units, 2 Marvair Units. o Disconnect any electrical and piping. o Install two (2) standard 2.5 ton Marvair Compact II wall HVAC units with a comparable industry standard replacement. o Remove and replace one unit at a time to keep a/c running in shelter at all times o Perform all necessary Unit System Electrical Wiring. o An optional upgrade to the existing ComStat III or IV controller or replacement that will enable IP based remote control and monitoring is requested. o Lead/Lag operation shall be configured. o Perform Start Up and Test operation of new system and provide functional test written report to Project Manager o Obtain any necessary permits and/or inspections