Site work and paving for a road / highway in Hermanville, Mississippi. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Mill & Overlay approximately 18 miles of SR 18 from the Copiah County Line to the Beginning of the 4-Lane Section at Raymond, known as State Project No. SP-0039-02(054) / 108233301 in Hinds County Value Estimate range - $5,000,000 - $10,000,000 Project Completion: 163 Working Days For Federal Aid Projects the attention of bidders is directed to the contract provisions governing selection and employment of labor contained in the bid proposal. Minimum wage rates for Federal Aid Projects have been predetermined by the Secretary of Labor and are subject to Public Law 87-581, Work Hours Act of 1962, as set forth in the contract provisions. Unless otherwise set out in the bid proposal, all other projects are subject to the predetermined minimum wage rate set by the U.S. Department of Labor under the Fair Labor Standards Act. When a DBE goal is contained in the contract, the award will be contingent upon the Contractor satisfying the DBE requirements. Bid bond, signed or countersigned by a Mississippi Resident Agent or qualified non-resident agent, with Power of Attorney attached or on file with the Contract Administration Engineer of the Department, a Cashier's Check or Certified Check for five (5%) percent of bid, payable to State of Mississippi, must accompany each proposal. The attention of bidders is directed to the provisions of Subsection 102.07 pertaining to irregular proposals and rejection of bids. MSDOT - 18 - Mill and Overlay of SR 18 *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. A general description of the work required on the project is to mill and overlay approximately 18.2 miles of SR 18 in Hinds County beginning at Copiah County Line (BOP Station 10+00) and ending south of Raymond (EOP Station 1000+58). Due to recent bridge construction project near Station 52+00, the section for this project from Station 26+22 to Station 74+20 will be omitted. Details of specific work are mentioned in the following sections. Where milling is required, the Contractor shall provide outlets in the existing shoulders at sufficient intervals to prevent pooling or standing water on the milled surface; the cost of which shall be absorbed in other items bid.