Site work and paving for a road / highway in Raymore, Missouri. Completed plans call for site work for a road / highway; and for paving for a road / highway.

As of July 29th, 2022 this project is pending an award decision. RFP/RFQ/RFLOI, Street/Road Asphalt Milling, Miscellaneous, Paving (Highway, Road or Street) Description: ANTICIPATED SCOPE OF SERVICES: 60000 sq. yds. of full width milling 6750 tons of 2" Type 3 Recycled overlay Tack oil is to be Ultra Tack, Trackless Tack NTSS-1HM manufactured by Black ledge applied at the residual rate of .06 gal/sq. yd. CAT-TAC trackless tack manufactured by Hunt Refining applied at the same rate, or other approved trackless tack oil. Paving will not begin until the tack has broken. Milled surface is to be cleaned by a vacuum sweeper immediately prior to tacking. 1597 tons of full depth patching, Type 1 Recycled asphalt. Type II can be used on Hu Bach Hill, including surface. 2000 linear feet of deep crack repair on 18 streets. 10000 pounds of crack seal on two thoroughfares prior to micro surface 34980 sq yards of Type II micro surface on two thoroughfare streets; Fox ridge and Lucy Webb. Aggregate is to be steel slag. Re-striping two thoroughfare streets after micro surfacing. Install three, Pave way Systems, brick pattern crosswalks with 6" wide, white, thermoplastic borders. Asphalt is to be milled and overlaid 50 feet either side of the centre of the crosswalks prior to the crosswalk being installed. See the crosswalk on Municipal Circle at Centre review as an example. Provide traffic control that meets MUTCD standards for all phases of the project. See map for specific streets. All equipment, material and workmanship must be in accordance with the Specifications and other Contract Documents. Project manual, plans and specifications, and proposal forms may be viewed at the office of the City Engineer, 100 Municipal Circle, Raymore, Missouri 64083