Renovation of an educational facility in Sacramento, California. Completed plans call for the renovation of a educational facility.

Project consists of: Roof Replacement at Main Bldg, V Wing, Old Shop and Auditorium. The undersigned has reviewed the Work outlined in the Contract Documents and fully understands the scope of Work required in this Proposal, understands the construction and project management function(s) as described in the Contract Documents, and that each Bidder who is awarded a contract shall be in fact a prime contractor, not a subcontractor, to the District, and agrees that its Proposal, if accepted by the District, will be the basis for the Bidder to enter into a contract with the District in accordance with the intent of the Contract Documents. Main Building; Single Ply Roof Replacement: 1. Remove existing single ply, felt underlayment, and coverboard only leaving built up roof system in place. Remove and dispose of two-piece coping cap. 2. Mechanically fasten one layer of 1/4"Dens-Deck over entire deck. 3. Install crickets behind all curb penetrations. 4. Install mechanically fastened 60-Mil TPA roof system and associated components. 5. Extend base flashing up and over parapet wall and install new coping cap to match size and profile of existing coping cap. New coping cap will be fabricated from 24 gauge, Kynar coated metal. 6. Secure the top of the base flashing with a termination bar and install new counterflashing at roof to wall condition. 7. Install TPA Walkway Roll where shown on attached aerial view. 8. Replace all wood blocks with rubber blocks (see Section 1.4).