Renovation of an educational facility in Thibodaux, Louisiana. Conceptual plans call for the renovation of a educational facility.

HVAC Equipment Replacement, Main Building, Fletcher Technical Community College HVAC Equipment Replacement, Main Building, Fletcher Technical Community College, Thibodaux, Louisiana, Project No. 19-671-22-01, F.19002418. This project consists of removal and replacement of HVAC system components in the Main Building of the Fletcher Community Technical College in Thibodaux, LA. The building is a single story building with approximately 32,300 s.f. The building consists of a conditioned portion made up of classrooms, common areas, and administrative areas and an unconditioned portion made up of trade shop training spaces. Scope includes replacing 31 existing four-pipe fan coil units. This project consists of the removal and replacement of 31 existing four-pipe fan coil units, sheet metal duct plenums, branch duct, and diffusers at each fan coil unit.Remove and replace existing heat/chilled water control valves with electrically actuated, modulating valve packages and insulate any new piping. Remove existing outside air ductwork, provide and install new direct expansion packaged dedicated outside air system (DOAS) on roof. Provide new sheet metal ductwork system from DOAS to each fan coil unit. Remove and replace three existing down-blast exhaust fans on the roof serving men's restroom, women's restroom, and janitor closet. Test and balance all HVAC water/air systems.Clean and service existing air cooled chiller/boiler. Install new direct digital controls to control all mechanical systems (remote access capable). Remove and replace four gas fired unit heaters in the unconditioned shop space. Remove and replace condensate drain lines from fan coil units back to main waste connection. The scope of work will include any associated electrical, ceiling and roofing repair or modifications as required. The Designer shall prepare and submit all required drawings to Facility Planning & Control in AutoCAD and hard copy. Drawings shall follow the format specified in the "Instructions to Designers for AutoCAD Drawings Submittal". The available funds for construction (AFC) are approximately $1,100,000.00 with a fee of approximately $77,146.00. Contract design time is 180 consecutive calendar days; including 60 days review time. Thereafter, liquidated damages in the amount of $125.00 per day will be assessed. Further information is available from Mark Bradley, Facility Planning & Control, mark.bradley@la.gov, (504)568-8545. LIMITS OF PROFESSIONAL LIABILITY Construction Cost $0 to $10,000,000 $10,000,001 to $20,000,000 $20,000,001 to $50,000,000 Over $50,000,000 Limit of Liability $1,000,000 $1,500,000 $3,000,000 To be determined by Owner The tentative meeting date for the Louisiana Engineering Selection Board is Wednesday, October 12, 2022 at 11:00 AM in room 1-136A-B of the Claiborne Building, 1201 North Third Street, Baton Rouge, LA 70802. Applicant firms should be familiar with the above stated requirements prior to application. The firm(s) selected for the project(s) will be required to sign the state's standard Contract Between Owner and Designer. When these projects are financed either partially or entirely with Bonds, the award of the contract is contingent upon the sale of bonds or the issuance of a line of credit by the State Bond Commission. The State shall incur no obligation to the Designer until the Contract Between Owner and Designer is fully executed. Firms will be expected to have all the expertise necessary to provide all engineering services required by the Louisiana Capital Improvement Projects Procedure Manual for Design and Construction for the projects for which they are applying. Unless indicated otherwise in the project description, there will be no additional fee for consultants The method of Contractor Selection has not been Determined at this time