Site work for a municipal facility in Greenville, South Carolina. Completed plans call for site work for a municipal facility.

The County of Greenville is Seeking Qualified Contractors to Install Fencing at Greenville County Animal Care, Located at 328 Furman Hall Road, Greenville, South Carolina 29609. All inquiries regarding this proposal shall be submitted via the County's online procurement Portal, located at https://secure.procurenow.com/portal/greenvillecounty. Please note the deadline for submitting inquiries. All answers to inquiries will be posted on the County's online procurement Portal. Offerors may also click "Follow" on this proposal to receive an email notification when answers are posted. It is the responsibility of the Offeror to check the website for answers to inquiries no later than Thursday, October 26, 2022, 5:00 pm EDT. The scope of work under this project includes the removal of existing chain link a fences, gates and installing chain link fencing complete with all posts, braces, gates, and all other appurtenances in Three play yards throughout the shelter. Fence Fabric Wire Mesh- The wire mesh shall be Hot Dipped Zinc coated galvanized (class 2) wire per ASTM A392. The wire mesh shall be 9 gauge commercial with 2" diamond pattern with a minimum break point of 1,290 pounds. The fabric mesh shall be stretched taut and securely fastened, by means of tie clips, to the posts at intervals not exceeding 15 inches and to the top rails not exceeding 2 feet. Care shall be taken to equalize the fabric tension on each side of each post. Fence Framework All posts shall be steel pipe and shall meet or exceed ASTM standards, standard weight schedule 40. The posts shall be Hot-Dipped Zinc coated galvanized and the post length shall be adequate to support the fence height of 6 feet. Unless otherwise specified, line posts shall be placed at intervals of 10 feet measured from center to center of adjacent posts. Measurements should be made parallel with the ground surface and all poles shall be placed in a vertical position. Top and brace rails shall be galvanized steel and shall meet ASTM standards. Finish shall match the finish of the fence mesh. Tension wire should be added to bottom of fence. Gates, Gates shall be hot-dipped galvanized with the same wire mesh as the fence mesh. Contractor shall verify in the field the widths of the gates to be provided. Provide horizontal and vertical members to ensure proper operation and attachment of fabric, hardware and accessories. The gate frame shall be constructed from same material and finish as fence framework. Brace each gate with brace rails and diagonal truss rods. Gates, gateposts and gate accessories shall conform to the requirements of ASTM F900. Gates shall be provided with a combination steel catch and locking attachment of approved design. Stops to hold gates open and a center rest with catch shall be provided. Accessories Fence- fittings shall meet all ASTM F 626 standard requirements. All accessories shall be Hot-Dipped Galvanized material and meet or exceed ASTM standards. The finish shall match the finish of the posts and wire mesh.