Site work for a water / sewer project in Appomattox, Virginia. Completed plans call for site work for a water / sewer project.

TOWN OF APPOMATTOX APPOMATTOX, VIRGINIA CHURCH STREET WATERLINE REPLACEMENT The Project includes the following Work: Replacing approximately 6,225 LF of 4 water line with 8 water line with associated appurtenances in the Town of Appomattox as shown on the plans and as described in the technical specifications. Bids will be received for a single prime Contract. Bids shall be on a lump sum and unit price basis as indicated in the Bid Form. Include complete street mailing address with zip code, telephone and fax number with area code, and contractor's license number, if applicable. No partial sets will be distributed. The contact person for the project with Hurt & Proffitt is Bif Johnson, PE. Bidding Documents may be downloaded from the designated website. Prospective Bidders are urged to register with the designated website as a plan holder, even if Bidding Documents are obtained from a plan room or source other than the designated website in either electronic or paper format. The designated website will be updated periodically with addenda, lists of registered plan holders, reports, and other information relevant to submitting a Bid for the Project. All official notifications, addenda, and other Bidding Documents will be offered only through the designated website. Neither Owner nor Engineer will be responsible for Bidding Documents, including addenda, if any, obtained from sources other than the designated website. Partial sets of Bidding Documents will not be available from the Issuing Office. Neither Owner nor Engineer will be responsible for full or partial sets of Bidding Documents, including addenda, if any, obtained from sources other than the Issuing Office. Bid security shall be furnished in accordance with the Instructions to Bidders. Bidders shall submit proof of qualifications to perform the Work as described in the Instructions to Bidders. The procedure for withdrawal of bids shall be in accordance with procedure (i) of Section 2.2 - 4330 of the Code of Virginia For all further requirements regarding bid submittal, qualifications, procedures, and contract award, refer to the Instructions to Bidders that are included in the Bidding Documents. BIDDER'S attention is invited to the requirements of Section 54.1 of the Code of Virginia pertaining to registration which specifies the following with regard to contractor licensure and registration by definition: Class A contractors perform or manage construction, removal, repair, or improvements when (i) the total value referred to in a single contract or project is $120,000 or more, or (ii) the total value of all such construction, removal, repair, or improvements undertaken by such person within any 12-month period is $750,000 or more. Class B contractors perform or manage construction, removal, repair, or improvements when (i) the total value referred to in a single contract or project is $10,000 or more, but less than $120,000, or (ii) the total value of all such construction, removal, repair or improvements undertaken by such person within any 12-month period is $150,000 or more, but less than $750,000. The bidder shall place on the outside of the envelope containing the bid and shall place in the bid over his signature whichever of the following notations is appropriate: "Licensed Class A Virginia Contractor No. _." "Licensed Class B Virginia Contractor No. _." "Contract is less than $1,000 therefore licensure is not required under Title 54.1, Chapter 11, Code of Virginia (1950) as amended ." American Iron and Steel Section 746 of Title VII of the Consolidated Appropriations Act of 2017 (Division A - Agriculture, Rural Development, Food and Drug Administration, and Related Agencies Appropriations Act, 2017) and subsequent statutes mandating domestic preference applies an American Iron and Steel requirement to this project. All iron and steel products used in this project must be produced in the United States. The term "iron and steel products" means the following products made primarily of iron or steel: lined or unlined pipes and fittings, manhole covers and other municipal castings, hydrants, tanks, flanges, pipe clamps and restraints, valves, structural steel, reinforced precast concrete, and Construction Materials.