Site work and paving for a civil project in Irvine, Alberta. Completed plans call for site work for a bridge / tunnel; road / highway; and for paving for a road / highway.

Estimated Value: $250,000 to $500,000 The County is seeking Submissions from Contractors interested in becoming pre-qualified to bid on the Range Road 40 (from Twp. Rd. 244 to Twp. Rd. 250) base and pave. Range Road 40 is an existing gravel road located between Twp. Rd. 244 (Springbank Road) and Twp. Rd. 250, east of Highway 22 in the County. The scope for this project is to widen the existing width of the subgrade from 7.2m to a 10.5m wide subgrade to allow for a finished 8.0m wide paved surface. Culvert replacement, entrance improvements and drainage improvements are also part of this project. Range Road 40 Base and Pave Two (2) layers of Subgrade Preparation 37,450 m2 Subgrade Excavation 5,000 m3 Right of Way Excavation 3,240 m3 Common Excavation 3,750 m3 Remove and Dispose Culverts (C.S.P.) (up to 700 mm dia.) 105 m Remove and Dispose Culverts (C.S.P.) (over 700 mm dia.) 12 m Supply & Install New CSP Culverts - 450mm 66 m Supply & Install New CSP Culverts - 600mm 90 m Supply & Install New CSP Culverts - 900mm 12 m Supply & Install New CSP Culverts - 1200mm 12 m Non-Woven Geotextile 5,000 m2 Granular Fill (Des 6 Class 80) 11,500 t Granular Base Course (Des 2 Class 25) 26,300 t Asphalt Concrete Pavement - (EPS) M1 (PG 58-28) 7,100 t Topsoil Placement & Drill Seeding 34,200 m2 Erosion Control Barrier (Silt Fence) - Supply and Install 1,000 m Roadway Lines - Supplying Paint and Painting 3.24 km Pavement Message - STOP BAR 2 messages Remove and Reinstall Existing Signs 10 signs Supply of Signs, Aluminum 5.40 m2 *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document.