Site work for a pipeline in Pensacola, Florida. Completed plans call for site work for a pipeline.

The scope of work may include, but is not limited to, the following: Steel Main Install - Will include trenching, final clean-up, restoration, and provide a completed pipeline system ready for gas distribution as herein specified and according to the attached PE facility map/drawing and specifications. Main shall be made live as soon as practical. Steel to Steel Main Tie-in - Will include testing main, pigging line, installation of the necessary squeeze-off or steel appurtenances for gas control, as well as tapping through steel, and purging. Also includes final clean-up and restoration. All steel connections shall be welded connections (with no mechanical fittings). Abandon Steel Main - Will include installation of the necessary fittings, squeeze-off or steel appurtenances for gas control, as well as tapping through steel, purging abandoned facilities, and capping lines, per PE standards, and final clean-up and restoration. This Item is only paid when retiring existing pressurized gas system per project design. Dewatering pit/main line - Will include all equipment, labor, and provisions necessary to dewater when required for completion of work. All dewatering must adhere to requirements of Section 1.38 Environmental Hazards. Any questions concerning the proposal should be addressed and submitted in writing no later than May 17, 2023, at 10:00 A.M to: Dedria Lunderman, Assistant Purchasing Manager City of Pensacola 222 W. Main St. Pensacola, FL 32502 purchasing@cityofpensacola.com This project will involve installation of a new U.S. made seamless 6" steel gas main with an operating pressure of 200psi to replace an existing steel main infrastructure at Regulator Station 2 located at 4001 Lillian Hwy. All existing underground piping will be abandoned in place as shown on the Facility Abandonment Map. The incoming 12" steel gas main will have a 12" spherical tee welded to it and the 6" main before the header will have a 6" spherical tee welded to it. Once both spherical tees are in place and the new 6" pipe is in place, the 12" existing line and the 6" existing line will be stoppered and end caps will be installed. At this point the new 6" pipe will be made live. Once this part of the project is complete, the abandonment of the existing steel infrastructure will be completed. All pipelines abandoned must be purged and the ends capped. All work areas will be free of any coating prior to the start of the project. Coating removal will be performed by Pensacola Energy. A load of clean backfill will be provided by Pensacola Energy for the initial backfill. The remaining backfill will be completed by using the existing soil that was removed during the project. Please reference the attached maps for information regarding the existing facilities, proposed facilities, and abandonment of facilities.